I think the sliding screw comes up on the BEVEL side of the knive to keep the belt from torquing the knife down. The opposite sliding screw is positioned at the same height so when the knife is flipped it’s ready to go.
@erman0006
7 ай бұрын
TR Maker is best tool supplier. Thank you a lot of Mr Yücel
@trmakertr
7 ай бұрын
Thank you
@clovismcpony
3 жыл бұрын
Loved the review!
@ricbarker4829
Жыл бұрын
Good drinking game, drink a shot every time he says "literately"
@wh0tube
3 жыл бұрын
That’s mad, that is! Innit. 😉👍
@thomaschetney990
3 жыл бұрын
You should at start at 4 degrees for deep grinds
@Exmoorblades
4 жыл бұрын
Hes a handsome chap isnt he😀
@alexzoghlin9083
2 жыл бұрын
Looks like he could be an extra in a lord of the rings movie :>
@mikegracia1475
2 жыл бұрын
What is the angle tool you used to measure the angle? Not seen one of those before!
Пікірлер: 19