Using a dip oscillator to test the tuned circuit in an RFID card.
Though the picture isn't very clear, you can see that the meter needle dips when the RFID's resonant frequency is tuned in on the dip oscillator.
The RFIDs tested here use HF frequencies around 13 MHz. Note that some use lower and higher frequencies so may not be detectable in the range covered by most dip oscillators.
PS: If you liked this video please consider supporting Amateur Radio VK3YE by:
* Subscribing on KZitem,
* Checking my books page at books.vk3ye.com
* Shopping on Amazon via: amzn.to/3iiDQXv, or
* Shopping on eBay via: ebay.us/i9DuWP
(then if you buy something I'll get a small commission at no cost to you)
Негізгі бет Ғылым және технология Using a dip oscillator to check an RFID
Пікірлер: 3