I have a similar process, CBN 180, 400, 600, somtimes 1000 ... Then, at 1750 rpm - RockHard wool wheel with diamond spray to deroot on guided Tormek table supports (I.E. Knife Grinders Australia RIP Vadim), and to polish, I use 1750 rpm - leather wheel with white rouge. I'm right about 5 minutes start to finish. I have found this to the most efficient and predictable compared to belts. I still use belts but only for major repair work or profiling. Keep the videos coming. Great job Paul !
@Phil.D333
2 ай бұрын
What two CBN, one low and one high grit, were used here Paul? I can’t see it mentioned
@Phil.D333
2 ай бұрын
What two CBN, one low and one high grit, were used here Paul? I can’t see it mentioned sorry I’ve noticed in comments that one is 200 & the other 1000
@ALXSHARPEN
2 ай бұрын
Yes 200 and 1000 are my norms I also own 400 and 600
@MericaMilitia76
Ай бұрын
The only downside is dust and the cleanup of dust.
@ALXSHARPEN
Ай бұрын
yep but for me its a garage shop so everything in here makes dust so thats why i had=ve down draft tables and air cleaners etc
@MericaMilitia76
Ай бұрын
@ALXSHARPEN I totally get it it. For me, I would not be doing the level of knives you are, haha. So cost wise, it is easier to just use a tormek with the water.
@davidstockbridge
Ай бұрын
No honing?
@ALXSHARPEN
Ай бұрын
6:35 I am honing it on the Tormek Leather wheel
@512Ryan
10 ай бұрын
Have you tried running both CBN wheels on one Tormek using the shaft adapter from the tapered honing wheels?
@ALXSHARPEN
10 ай бұрын
I have not tried it but have seen it done I don’t own the tapered hones yet.
@Phil.D333
2 ай бұрын
What Tormek part would that be to run 2 side by side?
@ruftime
Ай бұрын
Hi Ryan! I was planning on running two CBN wheels. I have the Slipakniven adapters(Schleif-junkies), as well as the Tormek honing wheel adapter(which needs a couple washers). The problem I'm encountering is too much run-out, from either adapter. Not as significant for the honing wheels.....but not acceptable for any grinding wheel. So I've added another T8 custom to my assembly line.
@Southernboy302
8 ай бұрын
Where did you get and what brand wheels do you have?
Пікірлер: 18