Sir, When scanning a weld in 10mm plate using 45degree probe. Range is 125. Machine shows SP=43.5, SD=30.7,D= 30.7. How can I calculate where is deffect??? Sir please help..
@garathbester
Жыл бұрын
Hi there Justin. It is difficult to say what you may be seeing on your screen with only that information but I can try to give you a few pointers. 1. A 10mm plate is perhaps a bit thin for a 45' angle. From what you are describing the sound is already on leg 3or 4, where you should try to get it on leg 1 or 2. I would recommend other angles like a 60' or 70' to get a better idea. 2. Review your procedure, it should give you guidance on what to do. 3. Plot the defect out, I have an example of this here : kzitem.info/news/bejne/2JhpyYhvs4OTdXo
@Oooni_Hz
7 ай бұрын
Learn the USM GO! stop using analog methods on digital machines the world has evolved
Пікірлер: 6