You should really fully dry the print before curing or you get white spots. I leave it for at least a couple hours or maybe 45 minutes in front of a fan. Happy 10th!
@Creality3D
5 ай бұрын
Thanks for sharing your experience! Drying the print after rinsing but before curing is effective in avoiding white spots for some special models. Appreciate the advice:)
@mackmind
5 ай бұрын
I'd skip the step of rinsing off not fully cured debris to sewer system. There shouldn't be too much of it anyway if you remove supports correctly. Otherwise it's a helpful clip :)
@Creality3D
5 ай бұрын
Thanks! Proper disposal is important though. Even small debris can add up over time. Still, appreciate the input!!!!
Пікірлер: 6