I had this exact noise on my vn2000 as well. First look to see if the lock nut to the pulley is tight with the lock washer crimped around it. If so then look at the pulley to see if there are any gaps between the teeth and the shaft. If so replace your pulley. With the new pulley check the gaps again. If there are still big gaps look into getting a new shaft as well. I only had to replace the seal around the shaft and get a new pulley. Now she runs like a champ with no noise.
@ronaldbdj
10 жыл бұрын
Hey Guy what was that noise related to I have that same problem with my VN2000, and I am experiencing the tapping noise in the clutch box area also.
@kaverdaja
10 жыл бұрын
i changed drive belt but didnt loosened tensioners thats when the noise started. so the belt was too tight. But i think that this problem can come back near future.(maybe bad bearings)
@kaverdaja
10 жыл бұрын
kaverdaja And to me tapping noise in the clutch box area was stretched primary chain whitch needed to replace, noise appeared mostly when engine was cold!
Пікірлер: 7