mine is home made, but all you need is a vac, a flat strong surface, a vac hose and some tools. i have a video on how i made a vac table
@mdstactical8912
2 жыл бұрын
Are you using 380° or 380f heat?
@FalTacUnlimitedLLC
2 жыл бұрын
380⁰f here in the states lol
@MrTattooed81
Жыл бұрын
I don't know if they work for everyone that's colorblind but I'm sure you have heard about the glasses that let colorblind folks see colors.
@NikIngersoll
Жыл бұрын
Excellent work. Ordered two holsters purely influenced by your YT content, keep it up.
@Yazzyb2024
Жыл бұрын
Would you mind sharing what laser u used to engrave your clip?
@boalbano9486
3 жыл бұрын
Finally found what I’ve been looking for for my P30sk. Ordered a light bearing holster from (something) rhino but failed miserably. Wonderful work man.
@isomwing
3 жыл бұрын
Always a pleasure watching you work, You rock dude.
@FalTacUnlimitedLLC
3 жыл бұрын
Appreciate it
@andrijamarinkovic9981
2 жыл бұрын
Greeting, I do the same job in my spare time, but I'm far from your level, but you help me a lot to improve and eliminate certain mistakes. I'm specifically interested in where you buy the molds for the pistol frames, cuffs and TQ... and where can I buy that heater? I'm from Serbia 🇷🇸 and I don't understand what you say (streap feather)?😂😂😂
@FalTacUnlimitedLLC
2 жыл бұрын
the heater is called a strip heater, thanks for the chuckle! also split molds are from palehorseconcealment.com full molds are multimolds from holstersmith.com and accessories are from oxcreaktactical.com or planbholsters.com
@andrijamarinkovic9981
2 жыл бұрын
Thank you for a quick answer! Keep up the good work!🥇💪🏻
@the941destroyer
3 жыл бұрын
Where do you get the gen 1 fabriclips from? What supplier? I find the gen 2 to be crappy.
@FalTacUnlimitedLLC
3 жыл бұрын
I got them from holstersmith.com a while back. Looks like they only do gen 2 now though
@MrTattooed81
Жыл бұрын
Enchroma glasses
@g36ak47cal45
3 жыл бұрын
Very Good
@LE-6920
3 жыл бұрын
Why this vid steel in 360p?
@claudefeghali5908
3 жыл бұрын
You're good
@mrbreihan
2 жыл бұрын
What kind of bit is that on your drill press?
@FalTacUnlimitedLLC
2 жыл бұрын
Centering bits
@Kurogane_666
3 жыл бұрын
I love your videos man, I was wondering could you use the same thing to make knife sheaths? A gifted China knock off broke on me and I'd like to have one as close to original as I can, any advice, it's a Gerber Strong-Arm if your wondering
@FalTacUnlimitedLLC
3 жыл бұрын
Knife sheaths in my opinion are far more easier on foam press. I have a video on a really nice od green knife sheath I did.
Пікірлер: 25