That extra head you put on @6:21 Looks really good on this guy. Looks like it came with him
@gtoney
Жыл бұрын
Those Alternate heads look great on that figure. Great 🥶 Review ✨️😃
@aaronscott5882
Жыл бұрын
A first-rate review of Scarabs and his cool accessories!
@sjkofi7935
Жыл бұрын
Glad you reviewed this! What led to here your thoughts. Thanks for all the head swaps! I saw that part of the video and was like” oh y’a you can do that!” 😅
@Nekro_216
Жыл бұрын
I've been contemplating to buy a few of these, but after seeing this vid- I most definitely will. I love the range of articulation with these. The head swaps make the possibilities endless. Thanks for the content. Always to the point and honest.
@TMan978
Жыл бұрын
Thank you for watching my content
@bodydoublesecurity4987
Жыл бұрын
I think I said this before, but I'm all in on this line! The series 2 figures are much easier to handle than series 1. Bobby really listened to the collectors and addressed all the concerns. I can't wait for series 3 to start shipping. Bring on the females! The only ones I'm missing is Bone Collector and that BotCon exclusive. Both shall be mine tho.
@snakeshadowcollectibles6835
Жыл бұрын
I've seen a couple of these Valverse Action Force figures and they look really cool. I might end up buying one or two.
@TMan978
Жыл бұрын
You should
@imm311
Жыл бұрын
I gotta get some of the Valaverse figs! Great review! God bless you and yours! Praying for you!
@TMan978
Жыл бұрын
Thanks
@nathanielmarrs1018
Жыл бұрын
I’d make a good aim soldier If the bee keeper helmet would go on
@starlord157
Жыл бұрын
You need to get the delta trooper. They are night and day better than the first wave.
@TMan978
Жыл бұрын
I shall look it up
@AlanDavidDoane
Жыл бұрын
@@TMan978 It is an awesome figure. Make sure you grab the Delta Gear Set as well to get him fully outfitted. The vest goes on and off like butter. They're learning from their mistakes, unlike many toy companies.
@AlanDavidDoane
Жыл бұрын
No force is needed to swap the hands, just 30 seconds in hot tap water or 10 seconds with a heat gun or hair dryer on its lowest setting. These figures, especially series 1, benefit greatly from the application of heat, and you only need to do it once.
@TMan978
Жыл бұрын
None of that sounds like a permanent solution. In my experience every time I figure cools off everything goes right back to normal unless cold water is introduced
@AlanDavidDoane
Жыл бұрын
@@TMan978 That's not the case with these figures, probably because they are made of a higher quality plastic than Hasbro or Mattel uses.
@TMan978
Жыл бұрын
I did the hair dryer method last night and after cooled off the hands were still hard to pull out
@AlanDavidDoane
Жыл бұрын
@@TMan978 Damn, sorry to hear that. I've had to apply heat to the hands of most of the series 1 figures, but I had no problem at all with my two Scarabs.
@James-ne1nl
Жыл бұрын
This is giveing mager Halo Emile-a239
@roadblock7801
Жыл бұрын
For a minute, I thought this was a Fortnite figure. Nice piece, though.
@rickytoddbotelho9555
Жыл бұрын
I resent the fact that you are using beachhead as a ' down ' background character. For this weird, fartnite facsimile to apparently have taken out. With it's heavy,flack vest. And weirdo aim or hive trooper looking helmet. Very unfartworthy 😛
@TMan978
Жыл бұрын
You shall get over it
@williamlaws9955
Жыл бұрын
Do the research on the line..
@TMan978
Жыл бұрын
Eh. Normally I do but I'm going to be completely 100% making up my own canon with any of these things I buy.
@williamlaws9955
Жыл бұрын
@@TMan978 oh and the hand gun is a maxium-9 real gun and guns I had to look it up
Пікірлер: 27