Excellent video, just replaced my gasket on the exact same vehicle model this morning. Thank you, appreciated.
@GrantBurton
Жыл бұрын
Hi Mohammed, it's a pleasure and thanks very much for leaving a comment. Soon there will be a How-to guide on replacing the OEM water bypass pipe with a replacement OEM 'MkII part' on this vehicle so keep a look out for that. The original is a plastic bypass pipe located underneath the intake manifold, which fails very often and the replacement part is a stainless steel pipe from Toyota. Video is still being edited.
@aliazm968
2 жыл бұрын
The mirror trick helped a lot 👍🏻 Thanks mate!
@GrantBurton
2 жыл бұрын
Haha 😂 It's a pleasure.
@KCMDWannabe
2 жыл бұрын
Making it look so achievable thanks mate!
@GrantBurton
2 жыл бұрын
It's a pleasure... hopefully this video along with some of my others are able to help others achieve things they would have not necessarily tried before.
@lildogg3
Жыл бұрын
Hey, Thanks for this great informative video, much appreciated.
@GrantBurton
Жыл бұрын
Hi Kyle, it’s a pleasure and thanks for your comment. There are a few other Hilux repair videos on my channel, not sure if you have seen those… in case you have other repairs to do.
@almuwahid9280
Жыл бұрын
Great video 📹 I have a 2008 hilux but it looks exactly the same as yours, gona give it a crack 😀 👍
@GrantBurton
Жыл бұрын
Hi Al Muwahid, thats great 👍 please let us know how the job turns out 😎⭐️
@ggbogo935
Жыл бұрын
you should always thoroughly degrease and clean the valve cover and the grooves in which the gaskets seats. any containments/dirt can prevent the gasket from seating and sealing correctly causing premature failure.
@GrantBurton
Жыл бұрын
Hi, thanks for the comment and great tip 👍 thanks.
@almuwahid9280
Жыл бұрын
You mean clean the outside of the cover before taking it off? I'm gona attempt doing the gasket my self.
@GrantBurton
Жыл бұрын
Cleaning the outside area and surrounding work area is a good idea, especially since the inner workings of the engine are being exposed.
@911engineguy
Жыл бұрын
Have you replaced your injector o rings on this engine yet?
@GrantBurton
Жыл бұрын
Hi Michael, no I haven't yet replaced the injector seals... We haven't had any trouble with them. Have you replaced them?
@911engineguy
Жыл бұрын
@@GrantBurton no .. I was replacing my rocker cover gaskets and noticed my injectors were leaking. Incidentally, I used gen Toyota gaskets, went for a drive today and I can see weeping coming around the centre bolts (not the perimeter bolts)... I used a fairly low torque .. approx 5nm. Maybe that was too much? By hand it feels pretty snug ..
Пікірлер: 19