This helped out so much! I am putting m50b30 in my e46
@Ace74477
2 жыл бұрын
Is it plug in or do have to do a lot of adjustments
@Wessel12
Жыл бұрын
What did you do with the cam sensor? The vanos cam sensor doesn't sit right in the hole so I keep getting a CEL.
@lukicdavid
4 жыл бұрын
Is it possible to do the opposite? I have nv cams, springs and all other stuff, except valves?
@KingMcAl
2 жыл бұрын
Hi! Is it possible to do the same with a double vanos unit as well?
@stiofane3669
5 жыл бұрын
stupid question but would it not be easier to transfer over the dual valve springs onto the m50 vanos head ? or does the non vanos head have other benefits that i dont know about ?
@vsomar9737
5 жыл бұрын
Stiofan e36 not a stupid question at all .... glad you asked.. taking apart m52 head to reuse stock m52 valves usually leads to destruction . The valves are 2 piece design so this will force you to purchase new valves and have a Frankenstein assembly in regards to valve springs retainers guides and valves . So to keep it budget oriented it is easy to with this route
@calobuilt831
2 жыл бұрын
@@vsomar9737 what kind of cam sensor are you using running on m52 cam trays and s52 cams
@REALSHYT666
5 жыл бұрын
Do the cams have to be swapped out as well or no? M52 cams in the m50 head or just use the m 50 Cam's?
@HimWitDaHair98
8 ай бұрын
Intake cam then has to be Vanos. M54B30 intake cam is an upgrade, M50NV intake then gets used as exhaust cam to match performance. This is harder to time as marks don't line up but it does work and improve power
@tyewvarnes
5 жыл бұрын
Are you doing this for higher revs? Or just for a beefier head to handle more boost?
Пікірлер: 12