Watch us apply "Peelstix - The stick on laminate" to a vertical application. Applications include interior doors, fire doors, accent walls, and cabinetry.
Peelstix by Dackor Installation Guide:
1. When applying laminate to a surface, stick the first 4 inches and firmly press down with your hands working your way from top to bottom and side to side. This will eliminate the possibility of air bubbles under the laminate. Next pull the backer down vertically, 3 to 6 inches at a time. This will allow all air to escape and for the laminate to be continuously pressed down to the surface of the structure. You do not need to pull on the laminate, let it relax and stick to the surface of the structure naturally. After the first section adheres, pull off the rest of the backer slowly, it helps to use your palm to firmly press down on the surface from top to bottom and side to side. It is not necessary to use any tools to press down on the laminate.
2. If you run into a situation where you need to pull the laminate off be sure to do it right away. After a few minutes, it will be extremely hard to remove. Continue laminating until the entire piece has been firmly applied.
3. Make sure to take your time with trimming. Use a utility knife with a new blade to trim off all excess laminate. Run your fingers around the laminate to feel for any overhang or rough edges. Untrimmed laminate can end up catching on things causing the laminate to be pulled off over an extended period of time.
4. The finished product can be easily cleaned using mild soap and water **No abrasives**
Негізгі бет Тәжірибелік нұсқаулар және стиль Vertical (Doors - Walls) Peel and Stick Application - Peelstix by Dackor
Пікірлер: 19