I know how you feel bro. I just replaced a broken kickstarter with a broken teeth yesterday It was a bitch to remove. the broken teeth became latches that prevents the kickstarter to come out. finally i had to use dremel to cut the starter. i never knew such a mundane kickstarter will be such pain in the ass.
@mattbrookes4622
6 жыл бұрын
If you haven't a source of heat or big compressor and gun this is a very difficult job. Perhaps the last owner rider lost the Jesus nut off the axle and rear wheel so went overboard on the tourque
@gavinbuckley7635
Жыл бұрын
Breaking my ❤ trying to loosen mine.
@danartriatmojo
2 жыл бұрын
For god sake, wth tighten that nut like that... even impact wrench couldn't even worked
@johnmckeever8889
6 жыл бұрын
Did it have bearing lock on it or something? Had one before that someone had used Tec7 to hold it on. Had to heat it almost white hot to loosen it. New hub bearing needed after.
@FreakMoPed8
6 жыл бұрын
Nono, it was just supertight so that it was driveable (i wonder this worked) with the two dead toothings
@george5590
4 жыл бұрын
i have had to replace two wheel, break drums , worn so the wheel does no grip ,and i think it will go the same way ?comments please
@FreakMoPed8
4 жыл бұрын
See the other answer
@nijanandteam
6 жыл бұрын
Does it damage the rims?
@FreakMoPed8
6 жыл бұрын
nope
@handyman7297
Жыл бұрын
Next time use some 3 in one oil, it will loose it
@FreakMoPed8
Жыл бұрын
thx. not sure if this would help. and u would have needed to put the vespa on the side u guess it opena easily with the lever extension
Пікірлер: 14