Here is a tutorial on how to setup your VFD and OpenBuilds BlackBox to accept control from the OpenBuilds Control Software. Follow the wiring in the video above.
****DISCLAIMER*****
These settings work and have only been confirmed to work with the 1.5Kw, 110v, 24,000RPM Spindle and HY01D511B VFD Controller! I have not tested these on any other VFD or with any other Spindles! Please take caution if using these settings with any other VFD/Spindle Combination. I take no responsibility if you fry your stuff!!!
****END DISCLAIMER****
Here are the VFD Settings. Do set these in this order:
PD013 = 8
PD001 = 1
PD002 = 1
PD005 = 400
PD004 = 400
PD008 = 110 (This is for 110V systems. If you are using 220V set this to 220)
PD024 = 1
PD070 = 0
PD072 = 400
PD144 = 3000
Set GRBL settings in OpenBuilds Control software to the following:
$30 = 24,000 (or whatever your maximum RPM setting is of your spindle)
$31 = 0
Link to my Spindle and VFD:
www.amazon.com...
Link to AirPump:
www.amazon.com...
Links to other info I used to help figure this out:
openbuilds.com...
docs.openbuild...
Here are links to download the different GRBL Post Processors that include the 8 second pause:
Fusion360: / 770491973473924
SoldworksCAM (File 1 of 2): / 770499930139795
SolidworksCAM (File 2 of 2): / 770500186806436
VCarve Pro: / 770500830139705
Let me know if you have any questions in the comments below!
Негізгі бет VFD Spindle Control via OpenBuilds BlackBox Controller and Software
Пікірлер: 84