Germans are the best at building and engineering. Excellent job
@P222RL
7 ай бұрын
1) balance the blade, 2) RPM 1,000 use 450 motor, 3) rotor head 3 screws , place the centre screw in the hole, tight the outer 2 screws while the centre screw can easy move around, once the other 2 screws are tighten, then tight the centre screw, screw in a screw at the top of the rotor, use the gauge to check if the rotor head is install perfect centre
@hubipilot4083
Жыл бұрын
Hab den Gleichen. Ich habe den Kompletten Antrieb nur unten am Fundament mit 4.X 4mm Schrauben befestigt so dass er mit samt dem Boden schwingen kann, mann braucht das nur fürs hoch laufen, alles ist absolut ruhig. Das Heck Rohr hab ich starre Ende verschraubt.
@P222RL
Жыл бұрын
suggest you use a gauge to check the main shaft and rotor head
@stopfen222
4 жыл бұрын
Hallo, hatte das bei meinem 800er Wolf erst auch. Habe die Heckantriebswelle und deren Lager getauscht, seit dem Ruhe.
@8ballout
5 жыл бұрын
WOW!! Ist das ein problem das durch schlechte Herstellung entstand? Hast Du das problem geloest?
@bladerunner469
5 жыл бұрын
It might be the Feathering Shaft that is Bent
@beyondxtream4056
4 жыл бұрын
Ich werde sagen . . . hoch heben und fliegen . . . Helikopter mussen fliegen :-)
@bjornvollheide7161
4 жыл бұрын
Pitch neutral mit -1.5° Grad ???
@1701_FyldeFlyer
4 жыл бұрын
Roban mechanics and especially main blades are known to be rubbish.
Пікірлер: 10