I think everyone who has experienced a sustained backfire can attest to the terrifying noise it creates.
@AmericanCoinHunting
5 жыл бұрын
Thank you .After over 40 years experience using the Qxy-Fuel torch , I knew what the Flash-back arrestors were for . This is the first time I heard an explanation of what the check valves were used for . Now to get some for my hobby torch , I already have the FB arrestors .
@fairwitness7473
4 жыл бұрын
Thank you for the information. I'm new to the oxy/gas torch use community. This was very educational. Thank you again.
@TheNigerianScammer.
3 жыл бұрын
Sustained back fire was kinda cool to watch on video never seen that before
@saginaw60
2 ай бұрын
A dirty tip (nozzle) will cause problems. To clean one, heat it red and pour water on it, then squirt compressed air!
@vievidsamc607
Жыл бұрын
Thanks for the video!
@muzafarhussain5853
6 ай бұрын
Nice 👍
@mainelyelectric
11 жыл бұрын
very good safety vid thanks for showing I love my oxy/fuel torches. I own 2 concoa cutting torches and a concoa rose bud I use on oxy/propane!! and I own a smith little torch with a very small oxy/propane rose bud!! Someday i will buy a victor for my farm!!
@nathanvince4728
3 ай бұрын
Why does everybody tell about the dangers of a flashback but not what to do if one happens
@atomichydrogenweld2823
2 жыл бұрын
really good information
@marynollaig4124
3 жыл бұрын
If a flashback arrester is fitted to both hoses, are check valves also required?
@brianhumphreys1660
4 жыл бұрын
Where can I get a Cut-away torch for teaching my new hires about torch safety in a more in depth class?
@ravanabrahmarakshas4263
3 жыл бұрын
Brian Humphreys cut it yourself. With a small grinder.
@abuakkas7863
5 жыл бұрын
Nice
@avinashdesai0206
23 күн бұрын
O keep working the window screws 0 😅
@hawkdaddy64
6 жыл бұрын
I have a Victor Medalist 250. I have a problem with it popping on me. Any suggestions will help.
@muddyudders
3 жыл бұрын
Clean the tips, check your working psi, increase your coupling distance, clean your metal. Are just a few things. I know your question is 2 years old but maybe it will help someone else.
@hawkdaddy64
3 жыл бұрын
@@muddyudders I had to totally disassemble the torch and found that the gasket that mounts the head to the hoses had a small sliver of gasket material blocking the proper seal of the two.
Пікірлер: 21