You did a fantastically complex and lengthy job with one hand, while also filming a video. It is very difficult. Hats off to your skill! Everything turned out very well. Thank you for the video!
@revvrav
2 ай бұрын
Thank you for the comment, was a challenge but very rewarding, I'll make another video of the 91mm when the build is complete. 🙏
@ignaziolentini7866
6 ай бұрын
Assurdo!complimenti
@Sokol10
7 ай бұрын
Nice job, but a bit expensive 58mm SAK. 😉
@revvrav
7 ай бұрын
Thanks! Was worth it for the challenge and knowing i personalised it for myself 😁
@matbuck1
5 ай бұрын
What are the specs of those little washers you use? Are they like the ones that come either side of the stock honeybee blade?
@revvrav
5 ай бұрын
Yea, they're the same ones that came with the honeybee made from phospher bronze, they're a little oversized for the victorinox but worked after I filled them down.
@nunyabidnez5857
6 ай бұрын
very nice. How long did this whole build take roughly, if you don't mind me asking?
@revvrav
6 ай бұрын
Thanks! I worked on it for around 3 weeks on & off, the longest part was waiting for parts to arrive from overseas.
@nunyabidnez5857
6 ай бұрын
@@revvrav thanks for the reply. I'm definitely gonna have to try to build one out for myself now.
@revvrav
6 ай бұрын
Awesome, it's quite a steep learning curve and a bit of trial and error but we'll worth it! I'm going to build a 91mm with the parts left over and more mods.
@nunyabidnez5857
6 ай бұрын
@@revvravsweet! I hope you post a video on that one as well. Does seem like a bit of a learning curve but at least it's not an expensive hobby to tinker around with.
@revvrav
6 ай бұрын
@@nunyabidnez5857 yea is relatively cheap to do, I'll be sure to post a vid for the new build too
@franksterkb891
Ай бұрын
good stuff! im just windering but why arent you using your left hand?
@revvrav
Ай бұрын
Thanks for watching! Due to a health condition i can't use my left hand
@franksterkb891
Ай бұрын
@@revvrav oh sorry for asking :( i hope you will be better
@revvrav
Ай бұрын
@franksterkb891 no worries! Required a bit of adapting but got the job done 😂
@franksterkb891
Ай бұрын
@@revvrav that makes the project more challenging, working and setting up your vlog is not an east task. hats off to you my good sir!
@revvrav
Ай бұрын
@@franksterkb891 for sure, took a number of weeks with slow progess and persistence. Currently planning a 91mm build with a cybertool and custom blade made by @sakworldcustom. I'll post a vid when it's ready. Cheers!
Пікірлер: 20