000 a generating coil should be made a certain way. there should not be too many winds or layers. (see a brooks coil, where the copper has a square cross-section.) the conductor diameter in a generating coil Should be equal to 14awg or equiv. smaller wire can be used if coils are wound in-hand. a coil so wound should produce relatively more volts, while having a nominal impedance value, when energized. (a poorly made generating coil acts as a current clamp. the amps out of such a coil will Always be underwhelming.) d note that: where the output of the prime mover is low-torque, the engine should be loaded in a way that gives it 'more' MA over the load. mechanical advantage; aka Reduction drive. doing this also partially isolates the engine from the load. d googletranslate
@workingtinkerer
Ай бұрын
It's all experimentation at moment, more vids to come, the window coil shows promise. next vid will have rectangle magnets instead. the goal is to run small radio.
Пікірлер: 2