Thank you. Takes some of the mystery out of it all
@russelldenton8753
Жыл бұрын
I just bought one. I was setting it up today. I noticed that the bolts that are supposed to allow you to adjust the height of the platen within spec of 1/8" of the pulleys. This is all in the manual. Did you have any issues with that process? I can't get the platen to move its height at all. There are no slotted bolt holes to allow for it.
@markgrimm3564
2 жыл бұрын
where do ya find out where to set the gantry for the differant radius i looked on the manual theres only 1 page
@VigilantGuitars
2 жыл бұрын
You can see my process around between the 10:50 - 11:50 mark. - fingerboard blank on tight belt - radius set on swing bar - adequate travel on fine tuners - raise the C brackets to to meet the swing bar pins. You have to adjust the 2 gantry arms every time you change the radius; it's not a one set thing. Once you have the arms set I recommend making a number of blanks so you have them on hand. Otherwise, it is a pain to reset the arms every time. Hope that helps!
@TheAyotteMan
2 жыл бұрын
I am a musician but I am not a guitar player. Do you feel like you absolutely need to know how to play it to make a guitar?
@VigilantGuitars
2 жыл бұрын
Absolutely not. Some of the best builders couldn't really play guitar - Leo Fender being the most notable. There are subtleties to the instrument that come with playing but if you're able to incorporate a guitarists recommendations into the specs of the build then your ability to play is not required.
@TheAyotteMan
2 жыл бұрын
@@VigilantGuitars Thanks for your response. They look like fun to make. 👍
@MrMorkev
Жыл бұрын
Big guy is explaining too much if You don't have to be so technical
Пікірлер: 10