I didn't stretch quite as hard, but this technique did the first 2/3rs of my caps done very nicely. Thank you!
@uniquecovering8095
Жыл бұрын
thanks for the help
@x3cerwin
7 жыл бұрын
You pulled that wrap like it was endless.
@jarradmcdonald2895
4 жыл бұрын
That's gonna fail 😅. Please, anyone watching, don't do this 😅. Should have pre stretched the vinyl, applied to the tip of the cone and then use heat to shrink the vinyl back to the edges. You want minimal tension on the edges while you can have tension in the centre. The technique down will give you the complete opposite result!
@rahilshaik6872
2 жыл бұрын
Yeah bro for sure 😂😂
@deathtotaxes
6 жыл бұрын
3M - Many finished graphic constructions can be stretched up to 150% (i.e., a 10 inch [25 cm] piece of film can stretch to 15 inches [38 cm]) without primer or relief cuts and maintain lift resistance;
@COBRACUSTOMS
8 жыл бұрын
they use Avery
@COBRACUSTOMS
8 жыл бұрын
I think the vinyl will turn back course the strach is to high
@shelbyweinstein4223
8 жыл бұрын
That's what happened to me after 2 1/2 days - It started peeling back over the edges.
@E11evens
8 жыл бұрын
You used the heat temp gauge when heating?? This isn't a true reading
@CaptainSteen
3 жыл бұрын
I thought you weren't supposed to stretch that much? Because the color underneath will come through and it will also make it weak. At least that is what most experts in other videos say.
@tylaferguson7078
7 жыл бұрын
waaaay too much stretch... i give that a week absolute maximum....
@braxtonbrown1333
4 жыл бұрын
Coming from someone who has been installing wraps for years, This will 100% fail. Stretching vinyl that much will not last overtime. Also, if you are using color vinyl, you will see major discoloration.
Пікірлер: 15