Nice walk around. I believe the oil temp gauge uses a type of ether in the tube, not mercury.
@nevillecapper6529
Жыл бұрын
Good video thanks The bodies were made in Glasgow,Scotland at Linwood /pressed steel, then sent to West Bromwich 250 miles away in England to be assembled by Jensen.
@MajTom-wd2yt
10 ай бұрын
5:00...Thanks for getting it right, no 'P'.
@buckwheatINtheCity
7 ай бұрын
Please note that the car has a mixture of Italian, English and American styling, done very tastefully.🎉
@chhindz
Жыл бұрын
Nice car I had white 122s 64 2dr, the SUs worked well.
@TheUltimate65
7 ай бұрын
Thanks for the sharing of the video, im teach some about it, p 1800 vas made in sweden and England , the difrent its the E and S
@olewurtz7625
4 ай бұрын
Eh, no ! S for Sweden, E for electronic fuel injection.
@gurra7473
Жыл бұрын
I got to drive one to prom!
@touraneindanke
5 ай бұрын
I know its extremely costly to replace the original chrome hockey stick strips on the side. But to be honest the car is only properly dressed with them.
@dand1800
Жыл бұрын
Very much enjoyed the Volvo video. I am rebuilding a basket case 68 1800S and the walkaround was very helpful. The car I am rebuilding only came with a speedometer (broken) so the interior shots were most appreciated. You state that is really a 67 because there are no side marker lights - correct? Thanks, Dan
@mitchellthomas4392
2 жыл бұрын
This P1800s is not in "...very, very nice shape". The boot lids warped, the engine bay has rust everywhere, the dashboard (what was shown) is coming away from the frame, front disc callipers were replaced, and BTW the 1 ft of chrome tail pipe is twin not the exhaust, and its rear interior has been recovered.
@jacquespoirier9071
Жыл бұрын
all the P1800 I've seen had a "warped" boot lid, it seems not worse that the other I've seeen
@MartinSage
10 ай бұрын
Could put a pair of Webbers on to increase performance
@robertbandusky9565
3 жыл бұрын
Thank you! Do you have any videos on spirt exhaust for 1973 P1800es? Thank you , Bob
@eurotechgreensboro2910
3 жыл бұрын
I don't have any videos on the exhaust system. All I can really tell you is that installing a new exhaust on an 1800 is very challenging. Every item is a very tight fit and it takes a lot of time to install it so that it won't rattle or scrape the ground.
Пікірлер: 20