Great video it was very helpful in understanding what that vortex does 👍
@BladeBarn
4 жыл бұрын
where can I see a video of the laptop spreadsheet table for ignition and fuel and how it connects to the ecu for advanced tuning?????
@georgesolomon5696
2 жыл бұрын
What is the process for ressetting? The instructions says "codes will flash until the ECU is reset by being powered down and restarted".. Is that just disconnecting the battery? For reference I have a 2022 KTM 500 EXC-F with FMF 4.1. I am getting a constant blinking code light and need to reset. The bike runs perfect .. Not sure why its blinking.. Thanks
@818blur
3 жыл бұрын
Does anyone know where I can find the chart of what the x10 maps do? I lost the sheet for my vortex ecu that I installed on my 2019 yz250f
@AOMC
3 жыл бұрын
Hi Alejandro! Vortex can help you! Thanks for shopping at AOMC! -The MX Guru
@marcissobadass
4 жыл бұрын
Exactly how do the low thru high settings work? Is 1 lean and 10 rich?
@jasonlowther7
3 жыл бұрын
does this work in conjunction with the Yamaha app for a 2019 yz450f?
@NickW90
3 жыл бұрын
It replaces your stock ecu so your power tuner app won’t work anymore
@2012skaterz2012
5 жыл бұрын
i have one on my yfz450r, (stock with FMF exhaust and Powerbomb header) its at lo5 mid5 hi 5 X10:1, I'm wondering if i have to increase it since its getting cold here in quebec, temperature dropped below 15 degrees and it was set at those parameters in summertime (75 degrees)
@bryzzers4282
5 жыл бұрын
Call Vortex ignitions for good Australian customer service.
@jaredallen8054
5 жыл бұрын
2012skaterz2012 no your efi bike has an intake air temperature sensor and changes the settings itself with the temp
@esdissonbenitopenarandatap2113
2 жыл бұрын
Jj
@ktmdays
4 жыл бұрын
Will the ecu change my rev limit do I need a tachometer for a ktm 500
@xXEYSPENXx
3 жыл бұрын
On the presets it says what it changes the rev limit too. I think the first 1-7 maps revs out to 10k rpm
@ManuelTorres-qy8op
4 жыл бұрын
I have a 2018 KTM 450 sxf which comes with factory 2 map, traction control and launch switch. Will I loose those switch functions with this ecu? Do I have to buy that extra switch to change maps on my KTM with the vortex?
@DoctorGoodnight
4 жыл бұрын
what did you find out on this?
@xXEYSPENXx
3 жыл бұрын
@@DoctorGoodnight idk if you got your answer for this, but the Vortex comes with its own launch and traction maps you can flip through
@jacobworld333
5 жыл бұрын
I have 2017 sxf250 . I want to take it enduro. Will that ecu help with stalling and power delivery?
@jaredallen8054
5 жыл бұрын
I have it on my 2018 rmz450 it’s far from stock and when I put this guy on I noticed an immediate huge change it was worth the 700 I paid I love it the bike starts first kick even when cold (after priming) and has a huge change in power. Now stalling you might have to work on that and your clutch fingers. I suggest a rekluse 3.0 exp clutch. You will never stall it again unless you have catastrophic engine failure I can promise you that
@450motodog8
3 жыл бұрын
Can you give me the map setting paper for 2009 Suzuki RMC 450 email to me I think my vortec was purchased in 2015
@vanman724
3 жыл бұрын
Anyone know where these are manufactured?
@martins78z
2 жыл бұрын
Australia
@vanman724
2 жыл бұрын
@@martins78z huh, interesting. They're sure pricey little units--about $800 US..
Пікірлер: 23