How about you show your viewers the up close results of your shooting and grouping of your shots?! From what I saw, it looked like every shot you made was just left of where you were aiming! If that’s the case, you might need to bring your scopes zero over to the right, like half a click!!! The idea with an optic like that is to get your rounds to hit where that center dot or the center of the crosshairs is, not a hair left or a hair right. Nor should you be hitting a hair high or a hair low. An optic should be used to remove as much of the human error factor from your shooting as possible!!! If your rounds are hitting where the center dot or center of the crosshairs is and the impact of your rounds is to one side or the other of your point of aim, that’s a trigger pull error on your part! If your rounds are hitting higher or lower than your point of aim, that’s a breathing error on your part. But if your optic is not putting the point of impact at the same point as your point of aim, then you are cheating yourself out of potentially perfect shots and a shot grouping where you could theoretically stack rounds in a single hole in your target!
Пікірлер: 2