It does tell you clearly in the manual that the notch in the ballpoint has to face forward in the direction of travel. This is what happens when people think they know what they are doing and get it wrong. Dumb mistake to make!
@diannereyes3680
4 жыл бұрын
You seem knowledgeable enough to help a gal out. Lol what kind of grease would you recommend on putting this entire piece back on? Lol funny but serious ☺️
@andrewwilson8317
6 жыл бұрын
Oh and they a pain to press out! Not much of a shoulder to support in press and bloody tight. Have seen them take 15 tons before they bang out! Be careful.
@stephenmargetjak6989
4 жыл бұрын
which direction do you press the lower ball joint out? pushing from the stud side?
@shortbusmat3425
4 жыл бұрын
Lower ball joint comes out the bottom of the control arm there's not much to hang on to be careful
@stephenmargetjak6989
4 жыл бұрын
thanks!
@stephenmargetjak6989
4 жыл бұрын
I put clamp press on the ball joint as tight as I could get let it sit it overnight.Took the set up off, the stud had been ground to a nub so I could fit the tool set up on. The ball joint had moved a few MM so I wedged a jack stand underneath to keep arm from moving and hit the ball joint stud about 30 times with a hammer and the sucker flew out.no heat.alot of wd-40.
Пікірлер: 7