I like how 150mm/s just doesnt look signifigant anymore even though its about triple what most can do ots
@kevinroosa1315
2 жыл бұрын
Yeah, the Rapido UHF is able to push far more plastic with a larger nozzle diameter. I can hit 45-50 cubic mm/s with acceptable quality using PETG and ASA using a 0.8mm nozzle, same extruder. With the 0.4, it gets choked up and can only push about 30 cubic mm/s.
@The.MrFish
2 жыл бұрын
Very interesting. I'm currently running an NF crazy high flow with, Bondtech CHT 0.4 nozzle and an LGX lite on my K3. I found that I was able to flow around 28-33mm3/s depending on filament. With the sherpa mini and specifically the ldo 17mm 8 tooth motor I was able to get over 40. Now I suspect I'm hitting thermal limits at about 28mm3/s and the extra torque is able to keep pushing through even at slower melt rates. This is with a 60w heater, however I suspect the ribbon and board I'm using may be introducing some resistance, so probably less than that's Not saying it will make your printer better at printing, but for sheer throughput I can recommend the sherpa mini with the 17mm 8 tooth LDO
@guillaumevanschijndel3435
2 жыл бұрын
Good pointer! I may check it out for vz235, i will test first a 0.5 cht in that thing as usually when the hotend is the bottleneck and u overpush flow the layer adhesion is super poor, next thing on that would be vez's new lsd hotend
@MichaelAronsen
2 жыл бұрын
How was 260c chosen as the right hotend temp? When I have pushed speeds over 500mm/s I have pushed all the way up to 300c on hotend. Different hotends, different Temps..
@AndrewAHayes
2 жыл бұрын
Nice! +1 Subscriber
@f1lab535
2 жыл бұрын
Very nice work, do you think it is possible to make it print with 5 colors? B-W-B-R-Y in order to create color prints
@guillaumevanschijndel3435
2 жыл бұрын
Uhmm all sorts of options right, MMU, enraged rabbit carrot feeder or change at height
@Drizzall88
2 жыл бұрын
Where did you get this an mount
@mathisgosselin5887
2 жыл бұрын
New idlers mount at the front👀
@guillaumevanschijndel3435
2 жыл бұрын
Yeah hehe thats a design i made a long time ago, made that now but moght switch to the official ones again like those too
Пікірлер: 19