At the beginning I was disappointed with the performance out of the box, after the firmware update it is like a new printer! Thank you very much!
@KenKlondike
Жыл бұрын
Thank You for the great video - Solved my problems
@5kopiyok
3 ай бұрын
In my D9 bed's temp sensor cable is shorter than the bed's power cable, so when bed moves through the calibration, the temp sensor cable is pulled off of it's socket on the PCB!
@iontechindia6002
5 жыл бұрын
Nice video very good information thank you
@avejst
6 жыл бұрын
Nice, thanks for sharing👍😀
@mamoshimiloni9559
11 ай бұрын
Please help. I have a wahhao duplicator 12/300 which I was so happy with. I was new in 3D printing and I have had it for a year, suddently everything died on it. the screen is gone and offcurse when the screen is gone you can not do nothing. At first I thout that the problem was the relay, so I ordered a relay for it, but it did not help. I had a powerfupply from a cnc project which could be used, so I tried that too, without anything changing. I am out of idea's. Just before the printer went down I downloaded a couple of files from the internet to print and I tried one of them. My friend says that I should have been more careful downloading files because sometimes there are bugs in them? I do not know anything about that. Please any idea what I can do?
@AlejandroBlanco-z4y
8 ай бұрын
Hello, I'm Alejandro and I'm writing to you from Argentina. I have a Wanhao D9 500 and it gives me a problem with the extruder heating. Could you guide me to identify where the problem is or give me a link to see how to solve it? thank you very much 20:27 20:27
@CoolGuyKyle123
2 жыл бұрын
Hello, I have tried this, however when I plug the printer into my computer, Xloader does not give me the option of the Arduino. Do you know how to resolve this? Com 4 does come up when I pllug it in. Thanks!
@sorento3489
5 жыл бұрын
Hi, Ive got a problem with z-axis which it doesnt go lower than a certain point. I researched a bit and I found out it is a common issue for Wanhao but couldnt find the solution. Please tell me how to fix the problem. thanaks
@jnsfrahm
5 жыл бұрын
Are you using Cura 4.0 or the Wanhao Cura that came with the printer?
@ViiKing_
5 жыл бұрын
How about making a comparison between the wanhao d9 MK 2, the alphawise u20 and the creality CR 10?
@Rimorox
3 жыл бұрын
Don’t buy the d9 it is the worst 3D printer ever designed
Пікірлер: 17