Bad News JBC Tools DDE-1C Soldering Station Big Concerns Check Your Firmware!! JBC USA reffed me to Spain, and Since JBC would not own up to the issue publicly I made this video detailing the issue.
Louis Rossmann Says it Well.
• JBC's handling of DDE-...
Live Teardown Investigation.
kzitem.infoF84nGxPrTaw
If you are affected by this also comment below.
My Personal Blog Post With Teardown Photos (Live Blog Changes Often)
www.stevenrhine.com/?p=131943
Good News SB244 Right to Repair Signed In to Law.
Firmware Comparison Starts About 17:00
California SB-244 Signed In to Law By Governor Gavin Newsom Thank You Sir.
www.gov.ca.gov/2023/10/10/gov...
www.ifixit.com/News/84491/cal...
I asked JBC how many units were affected my the micro controller substitution they did not respond, They should know they are the manufacture and know how many.
I know JBC took care of me by replacing the unit, But only after a complaint.
I am really starting to doubt my decision now on the JBC switch over from Hakko. I am some what committed but Not 100% sure I want to invest anymore of my money into JBC Tools taking into account the past issues with the hot air station sensor and this issue, Not getting a straight answer on the display question.
QR Codes:
DDU Bundle Marked DDE-1C 22O209 1487 MAT0070133 1000
DDE Single Marked DDE-1C 22O359 0451 MAT0070133 2000
@JBCSolderingTools @rossmanngroup @EEVblog
#righttorepair #jbcsoldering #jbctools #hakko
Негізгі бет Ғылым және технология Warning JBC Tools DDE-1C Soldering Station Firmware Issue! Right to Repair Signed In To Law.
Пікірлер: 63