If you have cracked plastic, drill a hole at the start of the crack to prevent it from further cracking.
@ExploreBeforeYouGo
17 күн бұрын
I will do that’s a great advice! Thanks for letting me know
@jasonk795
17 күн бұрын
@@ExploreBeforeYouGo seen people do it for ATV racer panels. 1/8" drill bit. Helps prevent more damage until you can fully fix it like you are doing. Your welcome. Hope it helps.
@ExploreBeforeYouGo
17 күн бұрын
@@jasonk795 thanks dear I will check it out for sure 🙏🙏
@twinkletoeswinckel478
17 күн бұрын
I never knew you could weld plastic
@ExploreBeforeYouGo
16 күн бұрын
Acuity very easy
@anthonykulas2624
17 күн бұрын
I did this on my accord bumper just without the proper setup, do NOT push too hard
@ExploreBeforeYouGo
17 күн бұрын
That’s right ! I was very careful when I was welding it I didn’t want to pierce it, it went pretty well
@davehercules2867
17 күн бұрын
Great tool! But.... You still need to weld the backside of the crack...
@ExploreBeforeYouGo
17 күн бұрын
Good to know I definitely do that, thanks for the advice!
@DlawarAb
17 күн бұрын
Pretty impressive
@ExploreBeforeYouGo
17 күн бұрын
Well thank you
@souleater3949
17 күн бұрын
Use a wood burning soder you can make it pretty much new looking without having to cut all the bits of metal out
@ExploreBeforeYouGo
17 күн бұрын
Good to know I have some other plastic parts have cracks I’ll give it a try thank you for the info 🙏
@KencoInventory2
15 күн бұрын
the gun wont get too hot ?
@ExploreBeforeYouGo
15 күн бұрын
No it’s just the welding material gets hot
@JBoogey806
17 күн бұрын
Is that the way they should be laid, it would be more efficient to turn them lil clips long ways and not side ways...
@ExploreBeforeYouGo
17 күн бұрын
Both ways works I wanted to make sure I can use more clippers on the part because wind hit that area more, so wish me luck
@JBoogey806
17 күн бұрын
@@ExploreBeforeYouGo for sure wishing luck bro, lol
Пікірлер: 19