Instead of taking that idler pulley off u can access the tensionor screw with a long extension and 8mm socket from in between the front number and plastic cover on bottom of car. Loosen the bolt that allows the pulley to slide back and forth first up top then loosen that tensioner screw thru bottom plastic cover by the bumper. The whole job is not for the beginners.
@seanshay7646
6 жыл бұрын
I can't find my EGR in my Nissan Sentra 2004 1.8 could you send a picture where it is in the car I have been looking and can't find it.
@davidm3210
5 жыл бұрын
I've got an '05 1.8L, and if I'm not mistaken it doesn't have an EGR valve.
@jamesmarinello9949
2 жыл бұрын
05 sentra 1.8 just completed this. It was easy for someone that is mechanically inclined
@MiBrCo4177
3 жыл бұрын
Late to the video but could anyone please explain to me how and or why, when after I've replaced the ect sensor and checked the radiator and everything else that my temperature gauge inside the car still climbs high all the way to the line below the H?. The water pump works as it's cooling it down bit for the life of me I can't figure out what in the heck it is.
@theodor.koerne
6 ай бұрын
You have air in the system
@DavidHernandez-ue4fz
6 жыл бұрын
How you get out the pulley?
@MRM-wp4gr
6 жыл бұрын
which pulley....the water pump pulley?
@DavidHernandez-ue4fz
6 жыл бұрын
MRM Yes.!
@MRM-wp4gr
6 жыл бұрын
If you are sure that the water pump is bad, you can leave the belt on until after you loosen the 4 small bolts that hold it onto the pump. That should put enough tension on the pulley so that you can break loose the bolts. That is the easiest way to do it. If the belt is already off, then you can wedge a screwdriver into one of the empty holes between the bolts to keep the pulley from turning while you loosen the bolts. After removing the bolts, the pulley should come off easily, or you may have to gently tap it with a hammer if it is stubborn. When installing the pulley, snug up the bolts by holding the pulley with your hand, and then you can fully tighten the bolts after the belt is on and properly tensioned
Пікірлер: 12