just to add if your water fills and falls down with gravity and disappears you need a geomentry in this case the actual original bathtub. in the tutorial what he says at 5 :07 to 5:20 is very important otherwise ur water will not be able to contain inside the source . and if you want more control on speed of water in bathtub you need to use a liquid simulator and initial fill inside it and then lower time scale to get more calm water.anyways the tutorial is fantastic
@MIMVizStudio
Ай бұрын
Thanks for the detailed explanation and sharing your experiences😊❤️
@dilaso
3 ай бұрын
Thank you, good job! You should take a 3ds max and vantage course, you are very good
@MIMVizStudio
3 ай бұрын
Thanks for the idea❤️
@Darya_yk
2 ай бұрын
The tutorial was accurate and excellent🤌🏻😍
@MIMVizStudio
2 ай бұрын
🙏🏻🙏🏻
@andrecordeiro4758
3 ай бұрын
Top! Top! 😎
@MIMVizStudio
3 ай бұрын
✌❤️
@abdulkadirdogan4741
3 ай бұрын
thank you soo much.
@MIMVizStudio
3 ай бұрын
🙏🏻🌱
@M.S.Rahimi
3 ай бұрын
The end result was amazing✨🔥
@MIMVizStudio
3 ай бұрын
🌱🙏🏻
@haneetkhanna1883
Ай бұрын
finally i found a tutorial that explains initial fill without using a liquid source but my water is falling into ground and disappearing after 30 40 frames. what am i doing wrong. its inside the object it fills like u have showqn but then it drops down like with gravity and then disappears
@MIMVizStudio
Ай бұрын
Thank you for your comment. Watch the tutorial again and go step by step.
Пікірлер: 16