Amazing review of stress strain fundamentals, probably best I've ever seen inside or outside of a university. Thank you!
@nwoodman1
3 жыл бұрын
Bravo Esfandyar! A very insightful presentation.
@pramitmajumder6355
3 жыл бұрын
Great content!
@burloakonario1759
7 жыл бұрын
Thanks a lot Esfandyar for your great and productive presentation!! Would you please post more of such a useful video?
@ginebro1930
7 жыл бұрын
Thank you for such a fine video!
@amrezz2955
6 жыл бұрын
thank you very much your video was very helpful for me
@gorraktech5988
6 жыл бұрын
Awesome presentation
@deanmillard9853
5 жыл бұрын
Amazing Webinar, can you recommend any books on plastic deformation?
@outagas2008
3 жыл бұрын
dividing the elastic modulus by 100 to get the tangent modulus gives 1% not the 10% stated. Which is correct?
@science_engineering
4 жыл бұрын
why do we have residual stress at the end of unloading cycle??? I mean that it's ok to have residual (plastic) strain and displacments when the force equals to 0. But i don't understand why we don't get zero stresses when the force equals to 0..........
@ahmadsaqlain487
2 жыл бұрын
need help? I want to do simulation of 3-point bending test of thermoplastic? i bend tha sample till 40mm displacement. please tell me which model should i use ? static, dynamic, linear or non linear , mises or hyperelastic?
@wiscgaloot
Жыл бұрын
This is no help at all, my Solidworks study screen doesn't look anything like yours. Using 2021 SP 5.1
Пікірлер: 12