I like that you're not afraid to show your welds. Looking forward to more cool contents from the channel.
@BulliKid
Жыл бұрын
Good job. I have the same welder.
@jasonwehrling738
2 жыл бұрын
Killer job on the piping welds look good too keep up the good work in the videos thanks for what you do
@HTMR
2 жыл бұрын
Thanks!
@MrGriffin23
2 жыл бұрын
Great work! New to the channels. Way tackle it yourself. I’m restoring a ‘71 Chevelle on my channel. I do mostly all my own work. It’ll be a boosted Procharged 6.0 LS engine. Great work! I subbed and tuned in.
@HTMR
2 жыл бұрын
Cool thanks. I gave you a sub as well.
@walterhuizer4568
2 жыл бұрын
Nice one Matt
@HTMR
2 жыл бұрын
Thanks Walter!
@Fab2Mc
2 жыл бұрын
Subscribed
@Leche_OG_
2 жыл бұрын
Good job. Great content on the channel!! What motor adapters are you using? Look to be a tight fit up front between the e-fans and front drive pulleys but it looks to be enough room for the turbo piping just fine.
@HTMR
2 жыл бұрын
I'm using the holley forward mounts and oil pan. Everything fits great.
@Leche_OG_
2 жыл бұрын
@@HTMRI’m on the list for the hydroboost bracket. Will you offer the cold side piping that you have on this set up?
@nickjonesrc
11 ай бұрын
How did you connect the 3D printed pie cuts together?
@HTMR
11 ай бұрын
Hot glue gun
@wags9777
2 жыл бұрын
I thought you were halfway around the tube and then you said," that's a good tack." You must have the voltage way down. I would have blown through the part, bench and the floor if stayed that long in one place.
@HTMR
2 жыл бұрын
Haha yeah I need to work on tacking much quicker. Yes I was easy on the pedal.
@boostedd15
2 жыл бұрын
Are you worried that your going to be blowing hot radiator air directly on to the pipe that you just cooled all the air in? I would think eventually that pipe will heat soak
@HTMR
2 жыл бұрын
Good point. Also, the turbo is going to be sucking in hot air off the rad as well. I could insulate the pipe later on. I also could add a duct for cooler air for turbo intake. I guess we will see what IAT's will be when it is on the road. I should also mention that I will be running E85 for higher boost levels, so intercooling is not AS important with that fuel.
Пікірлер: 20