great video, would you recommend installing a .355 shaft in a .370 iron head with a shim and collared ferrule?
@jerrygenex
5 жыл бұрын
I noticed that the collared ferrule easily moves away from the hosel along the time.
@petermartinaitis8166
2 жыл бұрын
Never had a loose ferrule on any clubs I've purchased in 40 years and there have been a few.
@oaker050668
Жыл бұрын
Is there a special ferrule for Callaway Diablo Driver?
@garyyip8854
5 жыл бұрын
Hi Ryan, another great video. Not to get to far away from the topic, but lets just say that the fit between the hosel and shaft diameter wasn't great and that you would need a shim so it wouldn't 'wobble' when you dry fitted. If you had the collared ferrule would you still need the shim? thanks again! :D
@ryanbarath1916
5 жыл бұрын
It really depends - If the fit is snug at the bottom you might nit but if there is still quite a bit of wobble then you should certainly use a shim. When in doubt use a shim in my personal ideology.
@JimmyGunXD556
5 жыл бұрын
Need some help. I have a Callaway X2 hot 3 wood when I pulled the shaft there is a brass pin fixed in the head. how can I remove it? Any help would be greatly appreciated thank you in a advance!
@ryanbarath1916
5 жыл бұрын
Great Question! That PIn is actually a weight. You can heat the hosel and use needle nose pliers to remove it. Built a TON of those FW and with a bit of heat and the right pliers you can make quick work of that tip weight.
@JimmyGunXD556
5 жыл бұрын
Thank you very much for answering!!
@shellyad100
4 жыл бұрын
Great vid thanks. .can I use metel ferrules for graphite iron shafts. Thanks Regards David
@ryanbarath1916
4 жыл бұрын
I have never used ferrules, but I would think if prepper properly there should be no issue
Пікірлер: 13