This channel is a treasure This series saved me lots of time reading the standard and I can jump to AXI 5 now Keep up the good work
@DillonHuff
5 жыл бұрын
Thanks Abdulrahman! I appreciate it.
@harishms1399
4 жыл бұрын
I felt AXI was very Complex initially but after watching your video series on AXI, now i am pretty much confident on AXI basics. thanks a lot Dillon
@naveedmohammad3666
2 жыл бұрын
Can you write any two test cases for AXI and APB
@madebytuna218
7 күн бұрын
Hey, what do you mean by "the memory isn't ready yet" for the wready signal? As in the burst controller hasn't generated an address yet?
@aakarshithasuresh3096
Ай бұрын
Thank you dilon for such amazing videos, simple and clear concise explanation😀
@jacklorance9621
3 жыл бұрын
How can I use axi 4 full custom package to send burst data. I used memcpy in the ARM, But burst transmission did not occurred! My axi full package is slave and connected to axi master GPO .
@shawn9652
3 жыл бұрын
I have a question Huff. So you have explained this based on memory as slave right all these signals will be opposite when we take a master
@DillonHuff
3 жыл бұрын
The master and slave are two sides of the same transaction, but the slave receives addresses while the master generates addresses. Not sure if that answers your question.
@shawn9652
3 жыл бұрын
@@DillonHuff that clears the doubt. I assume memory is the slave here and say nic400 as master
@coderhex1675
11 ай бұрын
this video saved my a$$ from reading the whole 300+ pdf specification
@harikrish29
4 жыл бұрын
Hi Dillon, Thanks for the video.. I have a doubt like Why AXI Write transaction has response(sent by the slave) at the end of burst whereas for the AXI read transaction has the response(again sent by the slave) for every beat in a burst.
@Ryan-Chinese-qq4qw
2 ай бұрын
What's the difference between bresp and bvalid since they all indicate wirte success.
@nmosfet5797
3 жыл бұрын
At 3:23 is the timing diagram correct? How can the memory set wready high before receiving the write strobe at the rising edge (red dotted rising edge)? Is the memory already expecting the strobe sio the wready is high even before actually receiving the data or is there just an error in the timing diagram?
@AbarajithanGnaneswaran
3 жыл бұрын
Just watched all 5. Was very helpful. Thanks a lot. Keep making more such videos!!
@shayakbhattacharyya2160
2 жыл бұрын
Should have started with this rather than dive straight into the ARM spec sheet. A really helpful playlist and explained in a lucid and concise manner. Well done!
@hramtekkar
4 жыл бұрын
In this 5 part video, you didnt mention anything about ARID and AWID. I think its an important aspect for read and write transactions. I was looking for information on ARCACHE/AWCACHE and found your part series. Great work. Can you please add another part jumping on to ARCACHE/AWCACHE?
@LaurentLaborde
5 жыл бұрын
i went from knowing that it's a 3 letter acronym to understanding how and why it works. thx
@DillonHuff
5 жыл бұрын
Glad you like the video!
@omkarpataskar5631
5 жыл бұрын
What happens when - 1) User sends more data then specified in the 'AWLEN' field ? 2) User does not set the 'WLAST' field while sending the last data ? PS - Your videos are really helpful. Thankyou.
@DillonHuff
5 жыл бұрын
Both of those situations are violations of the AXI protocol, so they are undefined behavior. What happens will depend on the details of the AXI implementation.
@phanisai22
5 жыл бұрын
Thank you for clear explanation. I appreciate your work for waves etc etc. could you make video on PCIe protocol also?.
@DillonHuff
5 жыл бұрын
I have never used PCIe, so I don't really feel qualified to make a PCIe video. That said a few people have asked for it, so maybe I will look in to the protocol and do an explainer video on it. Thanks for your comment!
@kdharmaji
3 жыл бұрын
Very nice
@sairam4515
4 жыл бұрын
Huge respect and apperication sir for your great work regarding this knowledge transfer by investing your time ,you're wonderful being.
@DillonHuff
4 жыл бұрын
Thank you sai!
@cratesurprise1259
3 жыл бұрын
You've done a great job Dillon. You should be proud of your channel, it's extremely underrated.
@DillonHuff
3 жыл бұрын
Thank you Crate Surprise! I'm glad you are enjoying the content
@deepagouravaram1633
Жыл бұрын
The content is so precise.. thank you for sharing such details makes a person understand without any back ground. I was hoping there was yet to come from this series sad to see we ended in slide number 55 where the presentation was intended for 93 slides
@rafeeqjohn
2 жыл бұрын
Thanks a lot.
@gauravtoshniwal7470
4 жыл бұрын
This is a very informative playlist. Hard to find such videos on digital electronics on KZitem. You should come up with more playlists on other protocols.
@DillonHuff
4 жыл бұрын
Thanks Gaurav. I've been busy with other things, but I may get around to it once I have more time.
@gauravtoshniwal7470
4 жыл бұрын
Dillon Huff Appreciate your effort. Have already recommended this to my colleagues and will look forward to your future videos
@srdjanbabic8304
4 жыл бұрын
Hi Dillon! Again, great explanation! I'll leave thumbs up as always. I've just watched your 'What is AXI' series, and it very good. I'd just suggest that you add one more video to this series, explaining unalinged write bursts, as I believe that they are mandatory for understanding the AXI any further + it's a good way to explain some meaningfull responses other than 'OKAY'. Thanks and cheers!
@DillonHuff
4 жыл бұрын
Thanks Srdjan! That would be an interesting topic for a video. I've considered doing an advanced AXI video series, but I haven't had the time.
@srdjanbabic8304
4 жыл бұрын
@@DillonHuff Glad you agree :) And the time issue, oh boy, I'm very well familiar with this problem :) Hope you get some time soon to do this, as I believe you'd nail it. Cheers!
@verifsudha5307
Жыл бұрын
@@srdjanbabic8304 Unaligned address with data bus boundary crossing and 4 KB boundary crossing explained here: kzitem.info/door/PLMlIDhv1FUAVOrUjbnUyp8Ja9aIYObxec
@ophiun2825
4 жыл бұрын
Quality Videos, and great mic quality. Context is clean and concise. Keep it up :)
@sp28769
2 жыл бұрын
Thank you so much for the crystal clear explanation.
@Manikumar-gt9ov
Жыл бұрын
Great AXI videos series. Crisp and informative.
@giacomo87v
5 жыл бұрын
Hello, thank you for the video. I have a question: the scenario is a master connected to a slave, where the master is a Central DMA (from Xilinx), that transfers data from a BRAM1 to a BRAM2. The connection is done using an AXI4 Full, with 32-bit data width. When asking the transfer of 16 32-bit words among the two memories, the transfer is done using only one burst with 16 beats (each beat with size 32-bit) , with the BRESP at the end. When asking the transfer of 17 32-bit words, the transfer is done using two bursts: one of 16 beats and another of 1 beat (in all the cases, the beat has 32-bit size). In this second case, the two BRESP referred to the two bursts arrive only after the two burst transfers. My question is: in your opinion, is this the correct expected behaviour of the BRESP signalling? Thank you for any feedback.
@DillonHuff
5 жыл бұрын
If the two bursts are done with different write IDs then there is no restriction on how they are ordered. If the two bursts have the same ID I don't know if that is legal. Section A5 (Transaction Ordering) of the AXI specification may have a more precise answer. Hope this helps.
@dharanikumar4873
3 жыл бұрын
That was a great explanation!!!.. your videos have a habit of making complex things look easier!.... If possible, please post an example of write bursts using WID .
@DillonHuff
3 жыл бұрын
I'm glad it was helpful Dharani!
@Rockstar007rk
2 жыл бұрын
This series helped me a lot.. Thanks a lot Dillon...
@backbenchers6864
3 жыл бұрын
Thanks Dillon Huff Bro, you are really really great and helpful. This series help me lots for understanding the standard spec. Your videos are pure desi ghee for me. Thanks a lot. Keep making these kind of video.
@DillonHuff
3 жыл бұрын
Thanks man. I appreciate it!
@abhishekvashisth8314
3 жыл бұрын
Great Job Dillon, very nicely explained
@bourbajoollof4232
5 жыл бұрын
you help me a lot, thanks from germany
@DillonHuff
5 жыл бұрын
I'm glad you thought it was helpful Bourba. Thanks for commenting!
@ozne_2358
4 жыл бұрын
Good video. Can the read and write ports operate independently and simultaneously ? I understand that, if the RAM is not dual ported (i.e. DRAM) some controller on the slave side will arbitrate the accesses it, but is it possible in principle (i.e. does it violate the AXI protocol using them at the same time) ? This would be useful if, for example, I have two processes, one that always write to the memory and one that always reads. In this case I could attach one to the write and one to the read port and let them operate simultaneously ?
@DillonHuff
4 жыл бұрын
Thanks Ozne_. "Independently and simultaneously" is a vague phrase. The AXI4 specification chapter A6 (Ordering Model) contains detailed information about transaction order. Basically streams of transactions in the same direction on the same transaction ID must look in order to the master, and the effect of any transaction (read or write) that the slave has sent a response to must be observed by all transactions issued after the response regardless of transaction ID.
@prannoyroy8753
2 жыл бұрын
Thanks Dillon, you made it simple and you are doing wonderful. I hope you get more inspiration from surrounding to create more such informative videos.
@DillonHuff
2 жыл бұрын
Thank you Prannoy. I hope so too!
@astghikavagyan1119
3 жыл бұрын
Thank you very much for the good explanations :)
@DillonHuff
3 жыл бұрын
Glad you liked the explanation!
@TominAbraham97
4 жыл бұрын
Thanks a ton Dillon for explaining AXI protocol in a simple way. I tried reading the user manual of ARM but it was a bit difficult to understand but, I guess now I will be able to understand it easily.
@DillonHuff
4 жыл бұрын
I'm glad this video helped! Those manuals are precise, but they aren't very good for understanding the basics, or the rationale behind AXI.
@kavinduvindikasomadasa352
4 жыл бұрын
easy to understand and great work with simplest possible explanation
@DillonHuff
4 жыл бұрын
Thanks Kavindu!
@Backrocks92
4 жыл бұрын
Good stuff. helpful
@jing-weiho3900
3 жыл бұрын
Thank you sir for a very clear introduction to AXI bus
@DillonHuff
3 жыл бұрын
You're welcome!
@divyakumarshah2498
5 жыл бұрын
Upload more videos
@DillonHuff
5 жыл бұрын
Is there anything in particular you'd like a video about?
@divyakumarshah2498
5 жыл бұрын
@@DillonHuff Yeah . I would like to have videos about implementation of AMBA protocol at RTL level , even any other protocol like pci,ddr will do. You are doing a good job. Thank you
@karan-dt5il
5 жыл бұрын
please do more deep in AXI
@DillonHuff
5 жыл бұрын
Is there anything specific about AXI that you would like a video on?
@karan-dt5il
5 жыл бұрын
@@DillonHuff ya bro i want you explain !) different types of brusts(fixed ,wrap,reserved) how they work and all..... 2) about chache support 3)atomic accesses 4)response signalling 5)about tag ID(whats the use) 6) ordring model 7)unaligned transfers 8) write stobes there are many students like me who appreceate your effort in explaining such complex protocal...........plz help us with this topics ...... i will surely reach your vedios to as much as possible auidence ....... give me your buisness email id so that i can send you specs from where i want you to cover topics thanks >>>>
@DillonHuff
5 жыл бұрын
@@karan-dt5il you can see my email at the top of my webpage: www.dillonbhuff.com/ Feel free to send me any material you would like me to cover. I can't guarantee that I will be able to cover them, but I will take a look.
Пікірлер: 74