Hi, could you share what is the IFP depth and a required pressure for TTX 2 air?
@traildogisla
Жыл бұрын
Coil version would be useful video for me
@outofblue9437
6 ай бұрын
Hi guys, thanks for the great video! do you have any tips for me: I have a TTX2 air. My HSC lever doesn't seem to make any difference and it seems a bit loose. Is there a way to address this issue without having to send the shock in? I'm in Germany and it takes up to 2 months for service...
@BRINKUK
6 ай бұрын
Hello! There is a very tiny grub screw that you might need to tighten in the little hole in the lever. Its a 1.5mm allen key and it clamps the HSC to the HSC assembly. Try that forst. You may need to try and few differant positions as the assembly may be all the way to the hard or the soft. I hope that helps! Cheers Mat
@ragged9242
Жыл бұрын
Any tips on dealing with that trapped negative air? I’ve equalized the negative and positive as much as I could and still get air trapped and when I un screw those screws theres a big pop and I blow a seal
@piotrekh7606
10 ай бұрын
Could you elaborate, on why a small volume damper is better for a high leverage ratio, like on your bike? And what do you mean by "better"? I am curious because I have the YT Jeffsy which starts from a 3.6 leverage ratio and a small volume RS Deluxe Air damper. It is way too progressive for me. With the correct amount of a SAG, I never use its full travel. I thought when applied some "bigger can", it would be more supple at the beginning and less progressive at the end of the stroke which would help me to use full travel. I am wrong?
@BRINKUK
10 ай бұрын
Should have said "air Can" not damper!
@BRINKUK
10 ай бұрын
If the small can isnt for you and want a more linear feel then go for the bigger air can for sure!
@toyotaRl
Жыл бұрын
I know of yous through Matt jones your bike shop is mad as
@toyotaRl
Жыл бұрын
I want him to come to Australia and ride here can you pls tell him to come here !! Pls❤
@BRINKUK
Жыл бұрын
👍
@rroche0123
Жыл бұрын
Good Vids, however the background music is too loud and distracting.
@BRINKUK
Жыл бұрын
Noted! Thanks for watching
@bobsaget3841
Жыл бұрын
Any tips for getting a new glide ring installed? I’ve found it is really difficult to get a new one on without marring or slightly disfiguring a side since the tolerance is so tight. I’ve got the piston band size tool for fox so once it’s on I can size it but it’s the installation that is really quite difficult and frustrating.
@BRINKUK
Жыл бұрын
Heat is your friend! Heat the piston band and that will make life easier, there's also a lead tool that makes it easier too. Thanks for watching!
Пікірлер: 15