Older American dryers motor controller relays. One relay would go bad all the time after a year or two of usage. Your video pinpoint what could potentially cause that issue.. nice video
@teckweelow5876
Жыл бұрын
Straight to the point with animation aiding , informative video !
@TheBadFred
2 жыл бұрын
What about a Schmitt-Trigger fror debouncing a switch signal?
@f-s-r
2 жыл бұрын
That works for small amplitude noise, but switch bounce tipically goes all the way to +V and GND.
@jeremyperala839
2 жыл бұрын
Can't believe there was not even one Tigger hidden anywhere in the video. Boing boing boing.
@msimon6808
10 ай бұрын
@@jeremyperala839 I have several. Zero Debounce Delay for an SPST switch with an SR Latch. spacetimepro.blogspot.com/2023/09/switch-debouncer.html
@wonderfulworld5134
Жыл бұрын
The input to a PLC needs to be debounced. Otherwise a software debounced timer, so a strong 500 milli second input is only what is accepted. They also can consider a hardware debounce electronics also if they have the electronics mind to.
@shervin9561
8 ай бұрын
Thanks a lot
@nicoy5079
6 ай бұрын
thanks!
@whippoorwill1124
Жыл бұрын
SR latches are complicated enough without careless errors. You can't make an SR latch with two AND gates as shown at 1:35.
@msimon6808
10 ай бұрын
Zero Debounce Delay for an SPST switch with an SR Latch. spacetimepro.blogspot.com/2023/09/switch-debouncer.html
Пікірлер: 12