Thanks... Well explained with a good example. This is excellent explanation. ❤
@passiontechmmr7748
10 ай бұрын
thank you brother
@marvinhenry1027
5 ай бұрын
Best explanation I've seen so far
@passiontechmmr7748
5 ай бұрын
Thank you so much
@kirkberryleo3307
3 ай бұрын
Sir, you are my new Hero. Im a novice in electronics and its my reg pwr supply Im trying to repair. My multi mtr showed nothing..my Esr mtr showed nothing and my component tester nothing.
@seremaiarabaraba296
Жыл бұрын
well explained... good job 👍
@passiontechmmr7748
Жыл бұрын
Thank you 🙂
@mrtechie6810
Жыл бұрын
For 220-240VAC -- Should I use a 431 or 471 volt MOV? What would be the difference in leakage current at 240VAC?
@passiontechmmr7748
Жыл бұрын
you can use either 431 or 471 for 240vac but for more safety 431 is more recomend to use which will protect more safe for your circut board.
@arkapadma
Жыл бұрын
@@passiontechmmr7748 what about 20D391K vs 20D471K?
@passiontechmmr7748
Жыл бұрын
@@arkapadma 20D391 is more protective than 20D471 if you are using in 230vac circut board.
@arkapadma
Жыл бұрын
@@passiontechmmr7748 thanks a lot.
@safasdaasdasgfafs
6 ай бұрын
Is it still safe if we connect the varistor to L and N without fuse?
@passiontechmmr7748
6 ай бұрын
No safe, fuse is necessary calculated by load Amp since varistor is for surge protection so it must be both use .
Пікірлер: 14