The vertical beam is supposed to be at an angle to the horizontal. However, the connection flange is welded at an incorrect angle in relation to the door hinges. It is possible that the 180 degree hinges are designed differently to the 270 degree ones. I am looking at cutting and resetting them. I am also looking at putting a threaded plug into the 18mm holes and drilling a 10.5mm hole to reduce the slop. Nothing as yet done though. As I say, you need to have access to a metal fabrication shop to fit this properly. Not something I expected for an aftermarket product.
@SydneyBuilder
Жыл бұрын
Thanks for the video. I’m in the market for a VW Crafter wheel carrier so this was a really great video to see. Sorry to hear about the hassles. If you had your time again, which alternative option would you go with?
@eckythump6429
Жыл бұрын
The holes you have are much bigger than on the 270deg hinges normally found on UK models. I guess there is probably an external difference too which might explain the gap you have experienced. Hope you got it sorted👍🏼
Пікірлер: 3