2007 Volvo S40 new tensioner replaced from alternator to ac. Replace the alternator with new tensioner. Drove fine for three days no codes. Belt broke from Crankshaft to AC compressor. After replacing broke belt. Crank no Start. All wheels on tensioners are fine. Crankshaft works fine. Any suggestions?
@Marty09933
Ай бұрын
Hi @@5thsNGunz wow that’s a good question. I don’t know why the car won’t start a car will start without the serpentine belt. Just make sure all the pulleys are spinning, which you already did. I. know on some BMWs when the serpentine breaks the crankshaft will suck it up into the engine I’ve experienced that. I don’t know if the Volvo has that problem. Maybe the belt hit some sensor and broke it. Check all the sensors around there. Thanks for watching. I really appreciate you.
@HCBCHEMISTRY
Ай бұрын
I think my belt broke while driving. My car was smoking, and stalled but I pulled over. It’s night , I can’t see a belt, car won’t start. I’m not sure what’s wrong, but I was hearing that squeaky noise when the car started. I hope my engine isn’t busted, I can’t afford another car.
@Marty09933
Ай бұрын
Hi@@HCBCHEMISTRY I think you’ll be all right if it started and got you home but always pay attention to your gauges. They’re gonna tell you everything that’s going on if the car is overheating or anything else thanks I really appreciate you.
@davetheg28
Ай бұрын
Hi. I just got a new water pump installed on my 2008 Buick Enclave and the belt shredded the same day. Any idea why?
@Marty09933
Ай бұрын
Hi @@davetheg28 very sorry to hear that. Yes, you could’ve had an old worn out belt if the belt wasn’t changed or check all your pulleys AC compressor alternator see if the bearings are good and the pulley is spinning. Also, just check the water pump and see if it’s spinning without the belt on very rare, but I’ve gotten new parts that were defective. Thanks for watching. I really appreciate you.
@ArnoDorian-b1o
5 ай бұрын
What if the belt smokes and burn off and breaks. Is it normally the tensioner sliding off the belt causing friction? Or could be a compressor heating off the belt ?
@Marty09933
5 ай бұрын
Hi @user-vf3lx9qr2n like I said it could be as BBC simple as the belt was old and busted but usually when they smoke it’s a pulley that probably froze up could be AC compressor idler pulley, tensioner pulley. Just check your pulleys before you put a new belt on spin all the pulleys and see if they spin freely and if they do then put the belt on and see what happens thanks for watching. I really appreciate you.
@corceles
2 ай бұрын
My belt came off, because the brand new belt tensioner I bought snaped off at the bolt, so now I got a bolt in the engine. Do you have any Idea what could cause the tensioner to snap off?
@Marty09933
2 ай бұрын
@@corceles Hi overtightening the bolt or the bolt old and worn out thank you for watching. I really appreciate you. Hope you get it fixed brother
@Only1lilE
Жыл бұрын
nice job 👍
@Marty09933
Жыл бұрын
Hi 1BabyE50 thank you and thank you for watching I appreciate you
Пікірлер: 12