I have to make a piece of furniture for a Renault Grand Scénic, and I am going to make a lot of holes in the board, so I have wondered which bit would be the best to do the job well and I have tried the ones I had in the workshop, which are usually the most usual, I have been missing some in the comparison, but I hope it will serve for those who wonder the same and if not at least entertain a little, hehe.
- Күн бұрын
WHICH DRILL IS BETTER FOR BOARD - BIT COMPARISON - FOR CRIMPING FORSTNER WITH CROWN BLADE
- Рет қаралды 12,076
Пікірлер: 29