Replaced the drain pump. Couldn't figure out why it wouldn't stop sensing when I was trying it out for a test run. Manual test (as you described) indicated that I'm a dumb ass and forgot to turn the water valves back on 🤣🤦 Took me longer to figure that out than replacing the pump. Works like it should again. Thanks very much!
@quenialima1215
Жыл бұрын
Iu
@Maks.347
2 ай бұрын
Thank you. I did this and my Wash machine work again
@codyharmon9756
2 жыл бұрын
How do I bypass the lid lock. ?
@outdoor07
2 жыл бұрын
Excellent. Thanks you
@BreakDanceBros
3 жыл бұрын
You the man
@TimHarris-or7ph
Жыл бұрын
How do I find out if my lid is locked the red button
@elliselliswilkerson1189
4 ай бұрын
My whirlpool cabrio just like this machine will not spin out and lid lock goes out. Put new lid lock an didn't make a difference any ideas ??
Can you pls help as to why my washer isn't filling up at all? No cold or hot water?
@erikaand5019
2 ай бұрын
Valves open?
@theresachitram8744
Жыл бұрын
When I do the manual test it say E1 f9 on drain do u know what that means?
@erikaand5019
2 ай бұрын
E1F9 is drain pump. E1F9 is a code for bauknecht too.
@farhanajabbar3482
3 жыл бұрын
What year is this machine?
@ВладимирТащук
3 жыл бұрын
2015
@dillondoyle9400
2 жыл бұрын
So if the test doesn't go off when you manually test it, say the lid lock does that mean its broken?
@ВладимирТащук
2 жыл бұрын
Not necessarily, it could mean that the PCB is broken. You would start by replacing the lock and if that doesn't fix the issue then you put the old lock back and replace the PCB.
Пікірлер: 19