Visit my website at www.tamingofthedo.com...to see lots of other cool beauty and hair videos!
Whirlpool Refrigerator Not Cooling Water Dispenser Lights Flashes On and Off
If your refrigerator starts making a clicking noise where it sounds like the compressor is clicking on and off, and / or the lights on the water dispenser is flashing on and off, then you may have a faulty main control board.
This video will show you how to remove and replace the main REFRIGERATOR CONTROL BOARD W10310240.
If you call a repair company, they must be able to get the part, which most do not stock, plus it will cost upwards of $300 for the board brand new. I purchased a repaired board that I found on eBay sold by fixyourboard.com.
The part arrived in about a week and worked as soon as I installed it. The company also backs it up with a 2-year warranty.
Watch the video to find out more.
Once the part is installed, you will need to program the board. Here is a copy of the instructions that came with my board:
Part number W10213583 has been replaced with part number W10310240 now. The programming instructions should be the same for both control boards though.
Programming Mode:
NOTE: The Program Code is located on the Serial Plate on this unit after the word Code.
1. Press and hold the Door Alarm Keypad DoorAlarm.
2. Press and hold Freezer Temperature Down Keypad.
3. Release the Door Alarm Keypad DoorAlarm and wait 3 seconds.
4. The control will display PE to indicate the programming mode.
5. Entry is confirmed by pressing the Freezer Temperature Down Keypad once more.
6. The control will display the current Program CODE. This value should be validated with the Program CODE printed on the unit serial plate.
NOTE: If the Program CODE is correct, the Programming Mode is exited by pressing Door Alarm Keypad for 3 seconds.
7. Press the Refrigerator Temperature Up Keypad or Refrigerator Down Keypad to change the digit value with each key press.
8. The decimal point indicates the selected digit. Press the Freezer Temperature Up Keypad to select the next digit.
9. Once the desired Program CODE is entered, press and hold the Freezer Temperature Down Keypad until the Program CODE begins flashing indicating it has been saved.
NOTE: If you attempt to enter an invalid Program CODE the control will not save the new code, but will beep. (The unit will NOT run with a Program CODE of 0000). Once the Program CODE has been saved the Programming Mode is exited by pressing any key. If the new code is incorrect this process should be repeated. The Programming mode can be exited at any time by pressing Door Alarm key for 3 seconds or will exit if unattended for four minutes.
#Whirlpoolrefrigeratornotcooling, #Whirlpoolwaterdispenserlightsflashesonandoff
If you enjoyed this video, SUBSCRIBE to our channel and sign up for your free beauty tips and news at www.tamingofthedo.com.
Thanks for watching!
My KZitem channel: / thesaloncenter1
Visit my other websites:
www.uniquesalonproducts.com
thesaloncenter.com
www.richardjrose.com
richleanfit.com
sugarfreespark.com
Негізгі бет Тәжірибелік нұсқаулар және стиль Whirlpool Refrigerator Not Cooling Water Dispenser Lights Flashes On and Off
Пікірлер: 118