Haha love the thumbnail (pew pew!). So glad you did this video! We got a diode laser too a couple of weeks ago but we haven't used it for anything but to engrave a few squares to make sure everything was good. I have it in my office and don't want to try doing anything with it until I have the proper set up. I also really appreciate you showing the settings you used for each material. The laser we got has its own proprietary software but I use Illustrator to design, so I'm not sure if I'll need to get Lightburn yet. If I do decide to get it, it's only $60, so it's definitely budget friendly. Thank you and keep up the good work!
@MakewithJake
2 жыл бұрын
Thanks for watching? What laser did you get? Is it that x1 I've been seeing around?
@mlob535
2 жыл бұрын
@@MakewithJake doh! I didn't realize I didn't answer! 😅 Yes, we got the xTool D1 10w and the 20w module. We also got the air assist and their honeycomb. I just haven't used it much because it's been too hot in Houston to work in the garage (plus my brand new Macbook Pro gets way too hot with just the minimum stuff open 😒). I did use it to cut something for my greeting card display, but that was the only time I used it and I was in my back porch. I may need to get an enclosure so that I can work from my airconditioned office.
@1915Woodworks
2 жыл бұрын
The video quality I wish to achieve. Well done as always
@MakewithJake
2 жыл бұрын
Thank you very much! Keep at it, you'll get there!
@TheDadCave
2 жыл бұрын
🤯 I had no idea laser is actually an acronym!
@MakewithJake
2 жыл бұрын
Make with Jake: blowing minds since 2020!
@TheDadCave
2 жыл бұрын
@@MakewithJake 👊😃 Haha, nice! Thanks for the rundown on this laser. Still looking to finalize which one I am going to get.
@curbshooter
2 жыл бұрын
A light video(s) would be awesome! Right from square one.
@MakewithJake
2 жыл бұрын
Wait, a video about light (photons) or a video about Lightburn? (Software) The scope of the video is drastically different between the two. Haha 🤣
@FirstFruitsDesignCo
2 жыл бұрын
You’re videos are awesome!
@MakewithJake
2 жыл бұрын
thank you!!
@RLLWoodworks
2 жыл бұрын
Very cool. Darn physics messing up the curves and angles when going too fast.
@MakewithJake
2 жыл бұрын
C'mon Newton! You ruin everything....
@MakerBeach
2 жыл бұрын
Could this unit be mounted on the head of an ill-tempered sea bass?
@MakewithJake
2 жыл бұрын
Absolutely. It's a bad time to lose one's head.
@faevalelo3174
Жыл бұрын
Please make a software video ❤ I need all the help I can get
@MakewithJake
Жыл бұрын
Ill put it on the list. Thanks for watching!
@PaulMarlmountWoodcrafts
Жыл бұрын
Hi, Is a Gweike I cloud 50w pro 2 laser cutter capable of cutting a juice groove in a cutting board ?
Пікірлер: 28