Can’t say I own one….but I know a guy who used a spring tech red buffer spring, with a 5.5oz buffer weight and a nickel boron BCG. It emptied a 30 round mag in about 3 seconds. Came out to about 600 rounds per minute. A lighter BCG may help the guy I know increase his rate of fire. Also he used green tip brass.
@billmyers6096
2 жыл бұрын
Just a thought worth considering: When I had a problem with steel case ammo, it turned out to be that the rings on my bolt carrier group were worn. I changed out the rings and didn't have any more problems with steel case ammo. Cheers!
@mindfactionpodcast5003
2 жыл бұрын
That may be my problem brass ran ok only thing I noticed was tords the end of the msg it slowed down when firing brass Steel was studdering
@tylertapp131
2 жыл бұрын
Good stuff, I figured that h2 and 3 would help it out. Bummer the steel doesn't run as reliable, but like you said, probably do to underpowered rounds not having the pressure to push that bolt as hard as needed. I'd say the h1 or carbine buffer and spring would probably be your best bet to have a chance to run steel and swap for the h2 or 3 for brass munitions. Good stuff bud!
@SHOTS-FIRED
2 жыл бұрын
My psa 10.5 with a h2 and wot runs steel fine. 60rd mag dumps without any issues. Brass will cycle faster though. I loaded 20 steel then 20 brass in my mag and you can clearly see the speed change when it switches to brass
@ElfSixDave
2 жыл бұрын
Hi Nerd, it's your favourite Elf here. Subbed you.
@oiaudacityio
2 жыл бұрын
Thinking about getting one. I've got an Odin Works adjustable buffer so hopefully I can get it tuned in. Also welcome to North Carolina.
@oiaudacityio
2 жыл бұрын
@Nicholas Armock I'm running all Tungsten weights in the Odin Works and I'm around 500 rounds in without any issues.
@oiaudacityio
2 жыл бұрын
@Nicholas Armock nice! I ordered some extra tungsten weights from a place called pure tungsten, they are the most reasonable price wise I've found.
@JamesIronSights
2 жыл бұрын
Not saying I have a WOT but steel is nothing but an issue with the WOT. Brass green tip is best. A 5.5oz buffer may be tested tomorrow buy someone lol
@maybeyournextdoorneighbor
10 ай бұрын
Yeah some body... but obviously a different some body than you right ? 😂 cause why would you have one of these "evil" things .. 😅😂
@Dedstik
2 жыл бұрын
Weigh your buffers and write the weight on the side of the buffer with a permanent marker. There is nothing “wrong” with your original buffer. Just buy a pack of titanium buffer weights so you can tune you buffers.
@chrisburger4518
2 жыл бұрын
I was curious on what buffer and spring combo too, since the WOT package calls for a H2 buffer. I called Geissele and they recommended their H3 and spring package ($99) when running a FRT trigger in a 7.5" AR pistol. They said their spring was 15% more stiff than a standard spring. FYI. Thanks for the video and helpful information.
@hondaservicecenter
Ай бұрын
What to do if round chambers but hammer follows or its a light primer strike, not sure what exactly going on
@practicerepo
Жыл бұрын
Good video from a good man. Awesome. Stay safe, buddy.
@louisdufour4106
2 жыл бұрын
H3 is my set up . My wot is wicked with the H3. I learned also you can run a H1 buffer with a grisselle spring the spring compensates for wright
@tracymaurer3297
2 жыл бұрын
It sounded like a lot of fun form here.
@Nerdgonesouth
2 жыл бұрын
Tons of fun fo sho.
@creade3783
2 жыл бұрын
I have never had good luck with steel or aluminum case ammo in any of my AR's. Not that they wouldn't fire, but they wouldn't cycle. Brass is best!
@WillysOverland
2 жыл бұрын
the steel does not slide as easy so it takes some of the return force off the trigger reset. A Wolf XP spring will help
@tso115
2 жыл бұрын
Iv been shooting tula 223, wot,and a alamo15 with a h2. No issues
@zenrider_9622
2 ай бұрын
H3 didn't work stock weight runs it get about 6 rounds then I have to charge it each time. Walking pins are tight, mil spec everything, so idk what's going on with it. Kinda pissed off with it.
@zenrider_9622
2 ай бұрын
@kikibarrios1231 it's one of the ones from ruger I'll have to double check the exact model. I got a full auto bcg I'm gonna try and the twisted buffer spring upgrade. And see how it does then. I've also got an Odin adjustable buffer weight.
@dustinharris7296
Жыл бұрын
I can't get anything but hammer follows. 8 inch suppressed pistol with h2. Adjustable gas block. Any help?
@maybeyournextdoorneighbor
10 ай бұрын
Try a h3?
@turbolegend3976
5 ай бұрын
@@maybeyournextdoorneighborpistol and suppressed might require extra heavy buffer. 7oz
@rmenard1986
2 жыл бұрын
Do you have an adjustable gas block on there? I've seen a few comments recommending opening the gas port to max to run steel case. Or if you can't run at all after changing buffer weights to try an adjustable gas block. I would rather try that than drill out a barrel.
@Nerdgonesouth
2 жыл бұрын
No, gas port isn't adjustable. Interesting thought though.
@MrTwocanchew69
2 жыл бұрын
Try the Super 42 combo by Geissele 👌🤫
@artbris16
2 жыл бұрын
👍
@kellycobean9616
2 жыл бұрын
I hate to be "that guy", but you never put your glasses on through the whole vid. Great vid, very educational, but please be safe! We need all the good guys we can get with two functioning eyeballs. :D
@rustyshackleford6693
2 жыл бұрын
He’s not shooting at steel he’s fine
@kellycobean9616
2 жыл бұрын
@@rustyshackleford6693 That's not the only concern. A case failure, a double charge, a squib...all reasons to wear eye-pro. And even if he's not shooting steel, ricochets happen off of rocks too. Eye pro is cheap insurance.
@christianthomsen9701
2 жыл бұрын
My buddies got crunchy after a few hundred rounds... a drop of oil on each friction point solved that
@juanarroyo465
2 жыл бұрын
Where exactly are all the friction points on that trigger?
@rustyshackleford6693
2 жыл бұрын
@@juanarroyo465 if you don’t know over lube and work backwards
@RobertThomas-l1p
3 күн бұрын
Taylor George Walker Anthony Thompson Richard
@joezepeda4056
2 жыл бұрын
It’s strange to me because he’s running wolf gold and calling it steel cased… regular wolf is steel cased but wolf gold is brass…
@joezepeda4056
2 жыл бұрын
Strange that he keeps calling it steel cased Ammo… regular wolf is steel cased, but wolf gold is brass..
@SamRice-j2l
16 күн бұрын
Thomas Mary Anderson Gary Anderson Karen
@yetisuncle666
2 күн бұрын
It says plain as day on the instructions to use h2 buffer. And you've had this ar for 10years supposedly. Surely within that 10 years your realized that steel does not agree with ar platforms regardless of trigger. This is beginner information. I can't believe you wasted this much film time on such a ridiculous "problem"
Пікірлер: 41