You could but the NRG brackets seems little tall to be adapted into stock brackets.
@kellypotter8759
Жыл бұрын
@@JimmyHasNoGarage Thank you for making this you did a really good job those PLM brackets look well worth a few dollars, thanks for the link and please, keep making miata videos haha
@gradof6b
2 жыл бұрын
Do these seats hit the door at all?
@JimmyHasNoGarage
2 жыл бұрын
Slightly touching the upper part when closed!
@professorpanda9165
2 жыл бұрын
Im kinda tall so if the seat was all the way back would I just need an extension tool to tighten the rear?
@JimmyHasNoTalent
2 жыл бұрын
This bracket won’t allow you to go all the way back parties with nrg seats
@quinlansmith5857
Жыл бұрын
I'm thinking about getting a prisma ultra for my s2k I'm 145 lbs and 5'8" however I have pretty broad shoulders. You think a medium would work?
@JimmyHasNoGarage
Жыл бұрын
maybe a little tight
@miataisalwaystheanswer1356
Жыл бұрын
Are these mediums? And was there any clearancing needed to install?
@JimmyHasNoGarage
Жыл бұрын
yup medium. Just the top part of the door touching a bit. I did nothing
@miataisalwaystheanswer1356
Жыл бұрын
@@JimmyHasNoGarage thanks for that. Really keen on pink ones for my mariner blue but don’t want to hammer the trans tunnel
@ilyushin1
2 жыл бұрын
I'm 5'11 - 160lb , my car has a hard top + getting probably an M2 harddog bar. Do you think mediums or large is best for me?
@JimmyHasNoGarage
2 жыл бұрын
Large won’t fit Miata’s without extensive hammering the trans tunnel that’s for sure. The seat will also hit door card. If you are 511 you probably won’t like the legroom I have with my setup as well (u would want it to sit back more I assume)
@ilyushin1
2 жыл бұрын
@@JimmyHasNoGarage sweet, for context, I do fit perfectly with the stock seats, don't need to put them all the way back. Hows the height of the seat compared to the stock seats? (I.e as tall as the stock seats or slightly taller, excluding the rails)
@JimmyHasNoGarage
2 жыл бұрын
@@ilyushin1 with plm mounts is closer to stock seats. NRG bracket on Oem slider sits very high
@ilyushin1
2 жыл бұрын
@@JimmyHasNoGarage thanks boss, this is a lifesaver. Not much information on NRG Prisma seats in miatas, so this helps a lot
Пікірлер: 21