I'd be interested to find out if any of the aftermarket heavier valve springs would fit. These diesels would work good with some boost but the valves will float like crazy.
@Trails_peak
Ай бұрын
would billet 196cc parts work on this?
@jwsbackyard6413
Ай бұрын
I don’t know. I’ve never had a 196 to compare it to.
@classyreaper5384
4 ай бұрын
Man I want to see the internals of one of these. So I can know what the cam looks like
@kemsouklowry9514
Жыл бұрын
How did you get the torque converter on? My shaft is to short?
@jwsbackyard6413
Жыл бұрын
As long as you can get the driver on the shaft partially (half an inch or more) you can just use a long bolt to hold it and it will work fine.
@kemsouklowry9514
Жыл бұрын
@jwsbackyard6413 ok thank you!!
@kemsouklowry9514
Жыл бұрын
@jwsbackyard6413 also did your belt line up straight? Mine is off center
@kemsouklowry9514
Жыл бұрын
Nvm I see the difference I got the torque converter with the mounting
@ScarletKnightmare
Жыл бұрын
Nice! Thank you
@playyachino2497
Жыл бұрын
Where u located
@illernpiller
7 ай бұрын
My question is if you had to modify how much fuel it was getting after the change in airfilter etc.
@jwsbackyard6413
7 ай бұрын
No I didn’t. It runs rich from factory so it had enough extra fuel to accommodate the extra flow.
@illernpiller
7 ай бұрын
@@jwsbackyard6413 Ok good to know. I'm about to buy a 9-10hp one and then do some slight mods.
@jwsbackyard6413
7 ай бұрын
@@illernpillerthat one should be fun, this one has always felt a bit underpowered.
@illernpiller
7 ай бұрын
@@jwsbackyard6413 gonna use it to power a water pump when I dig for gold =D
@AintNahThang
9 ай бұрын
Ive already seen some of your clips on my other account @OutTheGateMinis but imma have to watch the whole series for fun😂😂🤘🤘🤘 i love the build man
Пікірлер: 17