In this video I restore a 3 inch Wilton bullet 930 machinist vise made in 1946. The original bullet was designed in 1941. They range from sizes of 2 inches up to 8 inches.
I start with disassembly and use electrolysis to remove most of the rust, after electrolysis I move on to sandblasting all the large parts.
Once all the parts were cleaned up I turned my attention to the defects. I welded up the dents and missing letters. Cast iron is difficult to weld. After welding I had to file and sand down the parts.
I wanted to use a durable finish since this vise will get used. I chose a wrinkle black powder coat and I think it turned out great! The small parts were polished and then nickel plated for protection.
I hope you guys enjoyed the video, if you do leave a like and a comment. Subscribe if you would like to see more awesome content ;).
Much Love,
Dr Restoration
If you would like to support my channel check out my merch and Patreon: / @drrestoration
Patreon: patreon.com/DrRestoration
Facebook: / drrestorations
Instagram: / dr_restoration
Tiktok: www.tiktok.com...
Негізгі бет Wilton Vise Restoration | Wrinkle Powdercoat???
Пікірлер: 246