Speed. Relief cuts. Could have been chipped in half the time.
@Falcor73
4 жыл бұрын
I get paid hourly.
@MTnumber11
4 жыл бұрын
@@Falcor73 😄
@justingriffith2991
2 жыл бұрын
@@MTnumber11 hey
@woodnewf3847
Жыл бұрын
Pretty underwhelming performance from a large capacity machine. Too bad. Must be frustrating to work with.
@JustinNelson-kx7qy
6 ай бұрын
Dude don't even know how to run the machine woow this so sad to watch
@Cinderdick
2 жыл бұрын
Looks like you’re shoot got plugged
@Falcor73
2 жыл бұрын
We actually had Bandit come out and inspect the discharge on this chipper. The chipper had always had a problem with discharge velocity and chips “dribbling” out of the end of the shoot. Good observation, but to clarify, the shoot never became plugged. And, Bandit never found anything wrong.
Пікірлер: 8