I think I might want to get this one. Thank you very much for the video and the good build.
@JeffHartman
3 ай бұрын
I just discovered your channel. This is perfect. I love building models. I just have troubles painting. The way you broke it down in this video really helps me see how things work. Now if I can just figure out what colors to use, maybe I can actually finish a model. Thanks.
@The_Male_Modeller
3 ай бұрын
Glad you found it useful 😃👍🏻
@jamesmather2839
2 ай бұрын
Hi. Nice build. Off the top of your head, can you remember how much weight you added in the radio compartment? Many thanks.
@The_Male_Modeller
2 ай бұрын
@@jamesmather2839 I didn't actually weigh it but I essentially filled the compartment with a load of PK screws that I had. So it was a lot but there it the room for it. Sorry I know that's not hugely helpful, I should have weighed it before hand. I'll see if I can dig out the instructions, it might be called out 🤔
@NielsenDK-1
12 күн бұрын
Nice build👍🏼🍻😃 How was the decals and how did you apply them?
@The_Male_Modeller
8 күн бұрын
The decals went on really well. So, I've found the best method is, warm water, micro set and then apply. Use a cotton bud to get all of the moisture and air out so that they sit really nicely then, use a hairdryer (not for too long because you don't want to melt the plastic just enough to soften it and ensure that it's nicely set and the I apply micro sol a couple of times. I'll do a full video on it as it's a common question!
@NielsenDK-1
8 күн бұрын
@@The_Male_Modeller Glad to hear you had no trouble 😃 I"m looking forward to build my own and I have 3th party decals at hand. Just in case😂 Eduard recommends that you use no decal solution. There was a guide on February 2024 in their monthly news section, not sure, though.
@The_Male_Modeller
2 күн бұрын
@@NielsenDK-1 oh really? That's a surprise. I was doing some Eduard 109s yesterday and I found that using the hairdryer was amazing on them! Hairdryer then a cotton bud rolled over to get rid of any bubbles worked a treat!
@blarrrggg
3 ай бұрын
why the transparent tail parts
@The_Male_Modeller
3 ай бұрын
Just because they molded the clear parts into it. I thought it was unusual too but it does mean you get a better fit.
Пікірлер: 11