Attach the actuator and pull out the red pin that’s on top.
Slide the on/off switch to on. The red indicator light should start blinking.
After putting the batteries into the back of the thermostat, press the sync-button.
The red indicator light on the reciever should stop blinking and instead glowing steadily.
Hold the sync-button on the thermostat down for about three seconds.
The thermostat and reciever should be linked now. Check by turning the thermostat knob/ wheel to maximum temperature which is 30 degrees celsius. The indicator light on the thermostat should now be glowing red and the green light on the reciever should light up.
Негізгі бет Wireless room thermostat (one zone/coil) setup
Пікірлер