Check out my new video for wiring a doorbell. kzitem.info/news/bejne/xWOL3qONr3mGgXo
@georgiatrudell7787
11 ай бұрын
Attaching the doorbell to the mount is a little difficult but once it locks into place it seems extremely sturdy. kzitem.infoUgkxxHZwMa8CsRjYhf9s4W8w0Dwm47uytWOp I replaced my regular doorbell with this and hard wired it in, using my existing wires and mechanical chime. It works perfect so far and integrates perfectly with my blink camera system. It also works seamlessly with Alexa
@hayssamali3403
Жыл бұрын
You make very simple things very complicated. Thank though
@gabrielenriquemartinezllan9224
6 жыл бұрын
Thanks for your info!!!
@jesussalcido
10 күн бұрын
I know its an old post, but pencil and paper would make things look easer. (Kinder garden level schematic) Thanks for the video
@hoyboler5804
Жыл бұрын
Nice man !! well Explain!! thanks a lot !!
@eualiolozano6630
2 жыл бұрын
Usually how much do you charge for installation of this wiring door bell?
@johnq6123
3 жыл бұрын
Can you split the wire to make 2 separate chime connections? My chime burnt out when contractor was working on front door install (but he has no idea what could have caused it; LOL) I wanted to put double chimes side by side to replace old one (increasing DBs in same location); took the wire that was existing that was connected to burnt chime and spliced 2 new wires in (all 3 reds in one wire nut and all 3 blacks in the other). I already had 30amp transformer bc I wanted to this originally but never did. Thanx in advance for the help!
@33electric33
3 жыл бұрын
yes
@josep2807
2 жыл бұрын
Hello. I have a front and rear doorbell. I want to eliminate my rear doorbell. By simply disconnecting the rear terminal wire, will that be enough or do I need to do something else?
@519rudy
3 жыл бұрын
What if I have 3 sets of the white and red wire at transformer.....so got one goin to one doorbell and 2nd to other doorbell and 3rd to chime.....how do I wire them to transformer? Cant get it to wrk
@ClixWizard
29 күн бұрын
This would be infinitely more useful without a second doorbell in the circuit.
@MrCE1989
6 жыл бұрын
I purchased an Utilitech transformer (#0063548) that has three voltage settings (8V, 16V, & 24V) to replace a Nutone C905 transformer with one voltage setting (16V) for my doorbell. No matter what setting I put them on, both transformers only produce just over 4 volts when they are tested with my volt meter. I'm assuming something is screwy with the power source leading to the receptacle. Also, there's another wire leading out of the receptacle, but I have no idea what it leads too. Can you give me some advice on what possibly could be the reason why my transformers are not producing the correct voltage??? Supposedly, per the electrician who wired my townhouse, 120 volts is coming off the voltage source leading to the receptacle. He wants to charge me $120 to replace the transformer plus the cost of a new transformer. It sounds like the electrician has a real good extra moneymaking scheme going on here, especially with people who are replacing low voltage devices that require a little more voltage that the original device.
@33electric33
3 жыл бұрын
if you test the wiring with a meter and get 120volt to neutral there is no problem. I would then assume the transformer has an issue
@HsingSun
3 жыл бұрын
Where is the location of original transformer (I know it is in the attic)?
@quentinjohnson5732
4 жыл бұрын
trick or treat give me your dam candy
@opgnso
5 жыл бұрын
Decent instructions but would be a lot better if the unit was right side up not upside down, and camera recording wasn't jerking all over the place quickly. Very difficult to follow.
@dianneanderson731
3 жыл бұрын
My 1975 year old house doorbell box has 3 wires: blue, red & white. Is one a ground wire or what?
@33electric33
3 жыл бұрын
not sure but you shouldn't need the 3rd one but you may keep it just incase a wire goes bad, then you have a backup
@aerylletajonera143
6 жыл бұрын
Where can I find a bell transformer??
@readysetterrible3278
2 жыл бұрын
Where does the power supply come from ? A plug? Circuit breaker, can you show where is that goes
@33electric33
2 жыл бұрын
Check out the video I have pinned in the comments, has a better explanation.
@williammerritt3946
2 жыл бұрын
My house doesn't have wiring for a doorbell. I understand your video, but what about the wiring from the transformer to the actual power supply?
@mr.prince-qq8cu
10 ай бұрын
Black to black, white to white, green to green
@rudineclarke1995
7 ай бұрын
Is there a transformer that is for a house that has six doorbell chimes
@BharadwajAvva
2 жыл бұрын
Start watching from 1:00
@infotech902
2 жыл бұрын
Please tell me how the heck this door bell was working for 20 years if the transformers screw had no wire to the chime box ??? Can I send you the picture??
@vidatomica
4 жыл бұрын
I tried installing a new transformer, door chime, and door button at my new house but ended up giving up because there's something wrong. The thing is, I'm not sure if there's a short in the wiring or if the transformer is bad. Im getting 120V into the transformer and then 18V out of the transformer. I connected the white wire to T and the red wire to Rear (since that's supposed to give me the single "ding"). It worked but after like 30 minutes, the transformer got really hot, the chime box began to "buzz", and the white wire connected to the door button started to burn. Im using the old wiring that came with the house. Can you tell me what the issue may be, any suggestions, should I rewire everything from scratch, might the equipment I bought be faulty? Im at a loss.
@33electric33
4 жыл бұрын
Without looking at it I couldn't tell you exactly but it sounds like your transformer went bad. If your 120v is holding steady and your not having any fluctuation then it's not a voltage issue. Unless you made bad connections at the transformer, loose possibly but thats unlikely. Also test and make sure you get 120volts Hot to Neutral and not just Hot to ground. You may want to watch my other doorbell video on this channel. Its a better quality video for wiring up doorbell. Maybe you made a mistake somewhere with your low voltage wiring.
@TeslaEVVideos
3 жыл бұрын
Hi Can I interchange the wires on the transformer?
@33electric33
3 жыл бұрын
yes
@HsingSun
3 жыл бұрын
I would think so if it is ac power,
@qasion
Жыл бұрын
SO how do you wire 2 chimes to one door bell, I see you have 2 but you didn't explain?
@karolgurdian4659
11 ай бұрын
Same question here
@brianswails7276
2 жыл бұрын
I have this exact same chime..but I don’t have a clue where the transformer is..I need a more powerful one for a video door bell
@Faruk651
8 ай бұрын
probably on your electrical panel. If not somewhere in the attic attached to a junction box. It cannot be buried inside a wall so just look for it.
@dagucc7109
6 жыл бұрын
Will a 12v testing battery work for power?
@33electric33
6 жыл бұрын
Most likely not because the stepped down voltage from the transformer is still Alternating current, so it will most likely only operate with that.
@dagucc7109
6 жыл бұрын
33 Electric thx
@dagucc7109
6 жыл бұрын
33 Electric still very helpful I actually have a doorbell from 1927 and trying to find a transformer
@robertmunguia250
Жыл бұрын
Where is the transformer usually located?
@33electric33
Жыл бұрын
Usually in the electrical panel maintenance closet. Easy circuit in. But really, you can put it wherever you can pick up 120volts. Just put it in an approved electrical box so the 120volt connection will be to code.
@robertmunguia250
Жыл бұрын
@@33electric33 well, I tried to wire a eufy door bell camera and when I looked at the chime it had 2 sets of wires 2 red and 2 white. I shut off breaker to room but noticed wires still had power. Wired the door bell and now no power to it.
@AJCoReTV
6 жыл бұрын
Why does it go ding only? Instead of ding then dong?
@STV-H4H
6 жыл бұрын
One side of a chime is ding-dong (front door) and the rear door gets a single dong sound. So you know which door to answer,
@33electric33
6 жыл бұрын
I had 2 chimes delivered and the one I grabbed to test in the video ended up being defect. Realized that after vid, but the other one worked and went ding dong. Sent this one back, had it replaced. I installed 3 of these chimes at my customers house with this particular transformer and exact wiring in vid and they worked great. All 3 went ding dong. Thanks for your question.
@RollinHomies
5 жыл бұрын
It’s actually because it’s a 3 wire bell and he doesn’t know how to wire both sides. When you press the bell button it “dings” and when you release the button it “Dongs”.
@gabbyportillo9414
5 жыл бұрын
What size wire is it.?
@adamcunningham6847
5 жыл бұрын
@@33electric33 i was wondering the same thanks for the upload i have the same or if not a very similar chime tha only goes ding ,
@erict7867
4 жыл бұрын
If these wires aren’t going thru a wall this is worthless
@kaiserconstantine3338
Ай бұрын
I thought it was simple.
@Yeti420
7 ай бұрын
This guy sounds like he’s confused himself
@33electric33
6 ай бұрын
Check out my new video for wiring a doorbell. kzitem.info/news/bejne/xWOL3qONr3mGgXo
@rockg2593
7 күн бұрын
Bro you over complicated two wires
@juanorosco7041
6 ай бұрын
I’m fucking lost
@33electric33
6 ай бұрын
Check out my new video for wiring a doorbell. kzitem.info/news/bejne/xWOL3qONr3mGgXo
@DustyGonzo
3 жыл бұрын
You lost me at S.O.B.
@jeffsolinger5671
2 жыл бұрын
Absolutely terrible
@33electric33
2 жыл бұрын
Check out my new video for wiring a doorbell. kzitem.info/news/bejne/xWOL3qONr3mGgXo
Пікірлер: 62